Termostat termonic 17-1e.p65

SES ELECTRONIC THERMOSTAT
Electronic allround thermostat for all uses
For exact control action.
Certified
Structurgruppen AB
High protection class (IP 54)
LED indication
Sensor failure ind.
General use
Exemples of areas where TERMONIC can be used: Freezer rooms and air conditioning
plants, control and alarm of heating cable equipment, industrial process equipment, and
domestic applications.
Rinse proof housing (IP 54) allows installation in humid areas and outdoors
PRICE
SERVICE
QUALITE
- EVERY TIME
17-1E

SES ELECTRONIC THERMOSTAT
Function:
When the temperature at the sensor falls below the set-point-value, the relay switches and calls for heat, which is
also indicated by the LED. When the themperature rises, the relay switches back to the open position. To
control cooling action the load is connected to the open position. Installation manual shows open and closed
postions, heating or cooling action. Maximum load of the relay is 230 V - 10A.
The sensor is a semi-conductor, which gives an exact response to temperature changes. The sensor is supplied
with 3 m silicone rubber lead Ø5 mm. The sensor must be connected according to the colour coding.
The sensor cable can be extended up to 100 m in length by using 2x0,75 mm² cable, on the condition that
polarity is kept. If the sensor cable is to be placed close to strong magnetic fields (power current cables), cable
with metal braid should be used.
Each sensor is marked with its classification number at both ends of the cable. Calibrated thermostats have the
same sensor classification number printed on the cable between the circuit board and housing.
NB! These numbers must correspond for an accurate control.
Addtional functions and temperature ranges can be supplied, on request.
Technical data:
Power supply:
Control output:
Hysteresis:
Ambient temp.:
Housing:
LED indication:
Relay:
Description:
The electronic unit is encapsulated in a polycarbonate housing. The housing has three cable entrances for supply
and sensor. For ease of installation the terminals have double connections for phase, zero and PE.
Connections:
230 V Ac 50-60 Hz
230 V; max 10 A
0,5°C on/off
-25 - +55°C
wall mounting
Switching max 10 A
The thermostat circuit should be completed with an all-pole main-switch and a 10A fuse. The thermostat is supplied
complete with sensor and installation manual .
Zero
Load
Dimensions:
230V
max 10A
1 2 3 4 5 6 7 8 9 11 12
Structurgruppen AB
Gray
Sensor
(diod)
Black
82
38
76,5
Ø5mm
111,5
65
53
PRICE
15
3
SERVICE
QUALITE
- EVERY TIME
17-1E