OPUS - UrbanSim

More documents

Recommendations

Info

P. Waddell, 2010Estimating Model ParametersAfter experimenting, once you are happywith the results, you can save them to thedisk for use in simulation, by clicking onthe check box under EstimationConfiguration, labeledsave_estimation_results. You will need torun estimation again to actually save them.Thursday, September 16, 2010
P. Waddell, 2010Running a ScenarioOnce you have a set of models that havebeen estimated, you can configure ascenario to run a simulation over aspecified set of years.Let’s open an example, Eugene_baseline,which is set up to run by default just1981-82, for demonstration purposes.Right-click on the name of the scenario,and select Run Scenario. You should geta new frame like this.Thursday, September 16, 2010
Page 1 and 2: Introduction to OPUS: theOpen Platf
Page 3 and 4: P. Waddell, 2010Installing OPUS and
Page 5 and 6: P. Waddell, 2010Launching OPUS• T
Page 7 and 8: P. Waddell, 2010Launching the OPUS
Page 9 and 10: P. Waddell, 2010Organization in the
Page 11 and 12: P. Waddell, 2010OPUS Data ToolsTo e
Page 13 and 14: P. Waddell, 2010Viewing OPUS DataCl
Page 15 and 16: P. Waddell, 2010Viewing OPUS DataVi
Page 17: P. Waddell, 2010UrbanSim Base Year
Page 20 and 21: P. Waddell, 2010Inheritance in the
Page 22 and 23: P. Waddell, 2010Editing a Model Spe
Page 24 and 25: P. Waddell, 2010Editing or Adding V
Page 26 and 27: P. Waddell, 2010Editing or Adding V
Page 28 and 29: P. Waddell, 2010Estimating Model Pa
Page 32 and 33: P. Waddell, 2010Running a ScenarioW
Page 34 and 35: P. Waddell, 2010Generating Indicato
Page 40: P. Waddell, 2010Assignment 2• Tak

OPUS - UrbanSim

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?