NEC Programmer User Manual.pdf
NEC Programmer User Manual.pdf
NEC Programmer User Manual.pdf
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
VTOOLSHOPTel:+86-0755-27823977Web:http://www.vtoolshop.comwww.vtoolshop.com<strong>NEC</strong> <strong>Programmer</strong> - <strong>NEC</strong> Flasher Use <strong>Manual</strong>Connection between programmer and <strong>NEC</strong> PCB:black wire – GNDred wire – Power +5Vflat cable 1 ( red mark ) - <strong>NEC</strong> pin 25. Must be unsoldered from the PCB.flat cable 2 - <strong>NEC</strong> pin 7. Must be unsoldered from the PCB.flat cable 3 - <strong>NEC</strong> pin 1 ( <strong>NEC</strong> input from FT )flat cable 4 - <strong>NEC</strong> pin 19 ( reset )flat cable 5 - <strong>NEC</strong> pin 12 ( <strong>NEC</strong> output to FT )Note: In order to use again AVDI interface with any Abritus Commander, after usage of <strong>NEC</strong><strong>Programmer</strong>, disconnecting from both USB cable and OBD2 cable is mandatory. It is not possibleto work with Abritus Commander if AVDI is not restarted after work with <strong>NEC</strong> <strong>Programmer</strong>.
VTOOLSHOPTel:+86-0755-27823977Web:http://www.vtoolshop.comwww.vtoolshop.com