AFFF 3% A FOAM CONCENTRATE

AFFF 3% AFOAM CONCENTRATEDescriptionFomtec AFFF 3% A is an aqueousfilm forming foam concentrate (AFFF)consisting of fluorocarbon andhydrocarbon surfactants blended withvarious solvents, preservatives andstabilisers.The foam forms an aqueous film thatrapidly cuts off the oxygen supply andthus knocks down the fire. Theexpanded foam from which the film isdrained forms a stable blanket thatsuppresses the release of flammablevapours and cools down the fuelsurface extinguishing the fire andpreventing re-ignition.The low surface tension of the waterfoam concentrate solution enables theaqueous film, although heavier thanthe burning liquid, to float on top ofthe liquid surface.Fomtec AFFF 3% A should be used at3% proportioned solution (3 partconcentrate in 97 parts of water) infresh or seawater. It may also bestored as a pre mix solution in freshwater.ApplicationFomtec AFFF 3% A is intended foruse on class B hydrocarbon fuel firessuch as oil, diesel and aviation fuels.It can be used with both aspiratingand non-aspirating discharge devices.Fomtec AFFF 3% A is especiallysuited whenever rapid fire knockdownis essential. It is compatible withall dry chemical powders and can beused in powder/foam twin agentsystems.Fire Performance & FoamingThe fire performance of Fomtec AFFF3% A has been tested anddocumented according to the UKMinistry Of Defence Standard 42/40and EN 1568 Part 3 at 3%proportioning. Foaming index no lessthan 7:1 (normally 8:1). 25% drainagetime 3.0 minutes (normally 3.5).ProportioningFomtec AFFF 3% A can easily be proportioned at the correct dilutionusing conventional equipment such as:• Inline inductors.• Balanced pressure, variable flow proportioning systems.• Bladder tanks.• Around the pump proportioning systems.• Water turbine driven foam proportioners.• Self inducting branch pipes and nozzles.Technical dataAppearanceSpecific gravity @ 20°CViscosity approx @ 20°CClear Amber Liquid1.015 +/- 0.01 g/ml< 20 cStpH 7.5 +/- 1.0Freezing point - 5°CPour point - 4°CSuspended sediment (v/v) Less than 0.2%Surface tension approxStorage/Shelf Life20.0 dynes/cmStored in original unbroken packaging the product will have a longshelf life. The recommended storage temperature range of FomtecAFFF 3% A is from -4°C to 55°C. Freezing and thawing will have noimpact on the performance.Synthetic foam concentrates should only be stored in stainless steel orplastic containers. Since electromagnetic corrosion can occur at jointsbetween different metals when they are in contact with foamconcentrate, only one type of metal should be used for pipelines,fittings, pumps, and tanks employed in the storage of foamconcentrates.PackagingWe supply Fomtec in 25 litre cans and 200 litre drums. We can alsoship in 1000 litre containers or in bulk.International ApprovalsFulfills the requirements of the following standard:• EN 1568, part 3Dafo Fomtec AB, P.O. Box 683, SE-135 26 Tyresö, Sweden, Tel +46 8-506 405 00, Fax +46 8-506 405 29

Material Safety Data sheetAccording to 1907/2006/EG annex II (REACH-regulation)Latest Revision: 01/11/2008 MSDS No :Fomtec AFFF 1% A , 3% A & 6% A---------------------------------------------------------------------------------------1. IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND OF THE COMPANY/UNDERTAKINGIdentification of the substance or preparation : AFFF 1%A, 3%A & 6%AUse of the substance/preparationCompany/Undertaking identification: Fire Extinguishing Foam Concentrate: Dafo Fomtec AB, P.O. Box 683, SE – 135 26 Tyreso, SwedenTel: +46 8 506 405 66Fax: +46 8 506 405 29Emergency telephone :2. HAZARD IDENTIFICATION- Irritating to eyes3. COMPOSITION/INFORMATION ON INGREDIANTSNo Name of Ingrediant CAS-No EINECS-No Cons.Weight%1% A 3% A OR 6% A1 Water 7732-18-5 231-791-2 Balance BalanceHealth class2 2-(2-butoksyetoksy)etanol 112-34-5 203-961-6 10-30 1-10 Xi R363 Hydrocarbon surfactants --5-15 2-5 Xi, R36/384 Fluorosurfactants --

Material Safety Data sheetAccording to 1907/2006/EG annex II (REACH-regulation)Latest Revision: 01/11/2008 MSDS No :Fomtec AFFF 1% A , 3% A & 6% A---------------------------------------------------------------------------------------7. HANDLING AND STORAGEHandling: The product should be diluted before use. Avoid skin and eye contact. Use personalprotective equipment according to section 8. Avoid spill around the containers, thematerial may be slippery.Storage: Product should be stored in sealed, original containers. Freezing and thawing donot effect the properties but care must be taken to avoid freezing of the containerand its contents since the expansion of the container contents may cause cracking ofthe completely rigid container as ice forms. Do not store above +50C for longerperiods.Must comply to the national regulations for products classified as water hazardclass 1.8. EXPOSURE CONTROLS AND PERSONAL PROTECTIONOccupational Exposure limit values:2-(2-butoxyethoxy) ethanol CAS No: 112-34-5WEL-LTEL / ECWEL-STEL / EC-STEL67.5 mg/cu.m.101.2 mg/cu.m.Propane-1,2-diol CAS No: 57-55-6WEL-LTEL10 mg/cu.m. Particulates, 470 mg/cu.m. Total 8hr TWAExposure Controls:Hand protectionEye protectionSkin protectionRespiratory protectionEnvironmental exposure control: Work under local ventilation: Suitable gloves made from nitrile or butyl rubber: Use safety goggles: Use protective clothings such as overalls: Gas mask with filter type A may be used if concentration in air > exposure limit: Store or dispose concentrate in accordance with national regulations9. PHYSICAL AND CHEMICAL PROPERTIESType of material:LiquidColour:Clear pale yellowOdour:Organic odourSolubility:Miscible with water in all proportionsFreeze point:1%A = -20 C, 3%A = -5 C, 6%A = -3 CSpecific gravity at 20 C 1.00 – 1.03pH 6.5 – 8.5Boiling point100 C at 760mm HgFlash point:>98 CFlammabilityNot flammableOxidising propertiesNoneExplosive propertiesProduct has no explosive property10. STABILITY AND REACTIVITYMaterial to avoid: Keep away from heat sources. Avoid strong oxidisers.Conditions to avoid: Stable under normal conditionsHazordous decomposition products : Thermal decomposition of containers and/or products maygenerate acrid smoke, fumes, carbon monoxide, carbon dioxide(oxygen depleting), traces of nitrogen oxide and Sox.

Material Safety Data sheetAccording to 1907/2006/EG annex II (REACH-regulation)Latest Revision: 01/11/2008 MSDS No :Fomtec AFFF 1% A , 3% A & 6% A---------------------------------------------------------------------------------------11. TOXICOLOGICAL INFORMATIONAcute toxicity:2-(2-butoxyethoxy) ethanolLD50 oral ratLD50 dermal rabbitPropane-1,2-diolLD50 oral ratLD50 dermal Rabbit5660 mg/Kg2700 mg/Kg20000 mg/Kg20800 mg/KgAcute effects:Skin contactEye contact: Classified as non-irritant according to the dangerous preparation directive1999/45/EU: Can cause redness or irritation of the eye tissue12. ECOLOGICAL INFORMATIONEcotoxicityData has been deduced from a similar product1%A 3%A 6%ARainbow Trout LC50 (96 hours) >750mg/l >2000mg/l >4000mg/lDaphnia Magna EC50 (24 hours) >389mg/l >1000mg/l >2000mg/lPersistance and degradabilityThe product is biodegradableBOD ( 5 days )131000mg/lCOD141000mg/lBiodegradation 92.91%BIOACCUMULATIONNot expected to bioaccumulate due to metabolism and excretion.13. DISPOSAL CONSIDERATIONSWaste should be disposed via local authority waste collection service or registered waste carrier ensuring that thedestination is a licensed facility. All packaging shall be emptied and removed according to regulations, or be re circulatedwithout removal of labeling. Do not dispose with house hold garbage.European Waste Code : 16 Wastes not otherwise specified in the list1603 Off-specification batches and unused products160306 Organic wastes other than those mentioned in 16030514. TRANSPORT INFORMATIONNot classified as Dangerous or hazardous for transport under:ADR (Transport by road)RID (Transport by rail)ADNR (Transport by inland waterways)IMDG (Maritime Transport)ICAO (Transport by air)Not restricted for any mode of international transport

Material Safety Data sheetAccording to 1907/2006/EG annex II (REACH-regulation)Latest Revision: 01/11/2008 MSDS No :Fomtec AFFF 1% A , 3% A & 6% A---------------------------------------------------------------------------------------15. REGULATORY INFORMATIONClassification according to European directive 67/548/EEC and 1999/45/ECLabel For Supply : ONLY FOR 1% A & 3% AXFor 6% A None requiredIrritantRisk Phrases: R36 / R38 Irritating to eyes and skinREFERENCESHealth and Safety at work Act 1974Chemicals (Hazard Information & Packaging for supply) Regulations 1994 / Amendment 1996EC Directives: Substance Directive 67/548/EEC as amended by 69/81/EEC, 75/409/EEC, 79/831/EEC GeneralPreparations Directive 88/379/EEC. 1999/45/EC, 2001/58/ECClassification and Labelling of Substances and Preparations Dangerous for Supply.Transport of Dangerous Goods: ADR,RID,IMDG and IATAGuidance Notes: Occupational Exposure Limits EH40/96Note: EH40 is revised on an annual basis and latest issue should therefore be applied16. OTHER INFORMATIONRELEASED: 01/11/2008INFORMATION SOURCESDatasheet from the suppliersWork protection agency information pamphlet about protective equipmentWork protection agency information pamphlet about gloves“What you Need to know when you use protective breathing equipment” (Information, order number.: 539, Workprotection agency)Sax,N.I. and R.J. Lewis,Sr: Dangerous Properties of Industrial Materials, Seventh Edition, Volumes 1 to 3 (1991).DISCLAIMER: This information is based on our current knowledge and is intended to describe the product for the purpose ofhealth, safety and environmental requirements. The product should not be used for purposes other than fire fighting. The user isresponsible for ensuring that requirements of relevant legislation are complied with.