Brocade Edge M3000 SAN Router

SAN DATA SHEETMAXIMIZING SAN INVESTMENTSBrocade and its partners offer complete SAN solutions to meeta wide range of technology and business requirements. Thesesolutions include education and training, support, and services tohelp optimize SAN investments. For more information, contact anauthorized Brocade sales partner or visit www.brocade.com.BROCADE EDGE M3000 SPECIFICATIONSSystem ArchitecturePorts2 Gbit/sec Fibre Channel (auto-sensing);supports E_Port and F_PortWAN ports1 Gbit/sec Ethernet (with compression);OC-3 ATM (with compression);10/100 Ethernet (with compression)Classes of service Class 2, Class 3Management accessRS-232; 10/100 Ethernet (RJ-45)Warranty1-year limited warrantyPhysical SpecificationsEnclosure1U rack-mountable or tabletop(allow clearance for maintenanceand cable access)Height1.8 in. (4.5 cm)Width17.5 in. (44.5 cm)Depth14.5 in. (36.8 cm)Weight15.7 lb. (7.1 kg)Operating temperature40° to 104°F (5° to 40°C)Humidity5 to 90% (non-condensing)Input power requirements 90–240 VAC, 47–63 Hz, 2.5 AmpsAirflow60 CFMHeat dissipation844 BTU per hourFibre Channel SpecificationsDesigned to meet FCIP, FC, FC-2, and FC-BB-2 standards/emerging standardsCable typeOptical multimodeCore diameter62.5 microns and 50 micronsCladding diameter125 micronsNumerical aperture 0.275Attenuation (max.)1.5 dB/km at 1300 nm3.75 dB/km at 850 nmOperational wavelength50 nmBandwidth (min.)160 MHz/kmFiber countDuplexMaximum length50 microns = 500 meters at 100 MB/sec50 microns = 300 meters at 200 MB/sec62.5 microns = 250 meters at 100 MB/sec62.5 microns = 120 meters at 200 MB/secConnector typeDuplex LC connectorGigabit Ethernet SpecificationsSupports full-duplex Ethernet on each port and is designedto meet these standards:• IEEE 802.3z/802.3ab Gigabit Ethernet Standard• IEEE 802.3x flow control• IEEE 802.1p packet priorityCable typesMultimode, single-mode, and CAT5 UTPEthernet 10/100 SpecificationsSupports IEEE 802.3 and ANSI 8802-3 Ethernet 10/100 standards;uses CAT5 UTP cableOC-3 ATM SpecificationsDesigned to meet the following standards:• ATM Forum UNI 3.0 and 3.1• ATM Forum AAL-5• ATM Forum UBR, VBR, and CBR• ATM Forum af-phy-0062.000• ITU Recommendation I.432• ITU Recommendation G.704, G.704, G.707ATM Physical CharacteristicsOptical multimode Optical single-modeCore diameter 50 or 62.5 microns 9 micronsCladding diameter 125 microns 125 micronsBandwidth Up to 155 Mbps Up to 155 MbpsReach 2 km 40 kmConnector type Duplex LC Duplex LCRegulatory Compliance• FCC/EMC• Conforms with FCC Part 15 Class A subpart J, (U.S.A) EN55022 Class A,EN55024, 1998, EN61000-3-2/3• Safety: CUL 1950, EN6950 – IEC950Corporate HeadquartersSan Jose, CA USAT: (408) 333-8000info@brocade.comEuropean HeadquartersGeneva, SwitzerlandT: +41 22 799 56 40emea-info@brocade.comAsia Pacific HeadquartersSingaporeT: +65-6538-4700apac-info@brocade.com© 2007 Brocade Communications Systems, Inc. All Rights Reserved. 08/07 GA-DS-1020-01Brocade, the Brocade B-weave logo, Fabric OS, File Lifecycle Manager, MyView, SilkWorm, and StorageX are registeredtrademarks and the Brocade B-wing symbol, SAN Health, and Tapestry are trademarks of Brocade CommunicationsSystems, Inc., in the United States and/or in other countries. FICON is a registered trademark of IBM Corporation in theU.S. and other countries. All other brands, products, or service names are or may be trademarks or service marks of,and are used to identify, products or services of their respective owners.Notice: This document is for informational purposes only and does not set forth any warranty, expressed or implied,concerning any equipment, equipment feature, or service offered or to be offered by Brocade. Brocade reserves theright to make changes to this document at any time, without notice, and assumes no responsibility for its use. Thisinformational document describes features that may not be currently available. Contact a Brocade sales office forinformation on feature and product availability. Export of technical data contained in this document may require anexport license from the United States government.