vortex viper pst 6-24x50 moa rifle scope manual - EuroOptic.com

1. After filling the center gap on the post with shims, replace theelevation cap.2. Align the turret cap so the “0” mark on the cap matches upwith the “0” reference line on the turret post. Again, be sure notto rotate the actual turret mechanism in the process.3. Re-tighten the retainingscrews, but do not overtighten.Use of thumb and forefinger onthe short end of the hex wrenchwill provide sufficient force.Align the elevation turret cap.Using the CRS Zero StopOnce the CRS shims are installed, the elevation dial willstop turning shortly past the original zero point when beingreturned (turning clockwise direction) from a temporaryelevation adjustment.Point at which theknob stops turning.Indexing the Windage Knob1. Loosen the three retaining screws on windage turret cap.2. Carefully rotate the cap until the “0” mark on the capmatches up with the “0” reference line on the turret post. Besure that the cap is freely turning and that you don’t rotate theactual turret mechanism.3. Re-tighten the windage knob retaining screws, but do notovertighten. Use of thumb and forefinger on the short endof the hex wrench will providesufficient force.Turn the elevation knob a partial turn in a counter-clockwisedirection until the Radius Bar is correctly aligned with scopeaxis and zero marks match. This setting will match theoriginal zero point.Correct alignment forzero point.Once the windage and elevationknobs are correctly indexed to thezero mark, temporary correctionscan be safely dialed into thescope without worry of losing theoriginal zero.Align the windage turret cap.If re-zeroing at a future time, be sure to remove all CRSshims before sight-in.18 19