QCSA Handbook on scoring 2010 - Queensland Cricket

More documents

Recommendations

Info

Leg bye against batterLeg bye in Leg byes section Leg bye against bowlerAs with byes, you only record leg byes against the batter and the bowler asa record of what happened. Again, the batter has not hit the ball, thereforethe runs do not count towards the batter’s total, nor against the bowler’sprogressive total. An over that only contains a leg bye is a maiden over.Over shown as maiden forboth bowler and progressiveovers/runs record, despiteleg byes having been scored.WidesA wide is called when the ball bowled is not within sufficient reach for thebatter to hit it by means of a normal cricket stroke. When a wide is signalledby the umpire and no runs are scored, enter a W against the batter, 1 in theWides section in sundries, add 1 to the progressive score and enter a W inthe bowler’s column. Don’t forget at the end of the over that the Wrepresents one run against the bowler and has to be added to that bowler’sprogressive bowling figures.If the batters run when a wide is signalled, it is to be recorded as either W 1 ,W 2 , W 3 or W 4 , depending on the number of runs taken. The number of runsPLUS the wide itself will be awarded to the batting side. If one run wascompleted, enter W 1 against the batter, 2 in the Wides section in sundries, 2to the progressive score (1 run plus penalty 1) and W 1 in the bowler’sfigures. If the wide ball goes to the boundary, the umpire will signal thewide first, then the boundary, so this will be shown as 5 runs in the Widessection and on the progressive score, and W 4 against the batter and bowler.Wide against batter Wide in Wides section Wide against bowler34Queensland Cricket Scorers Association
At the end of the over, remember to add the wide penalty and runs scoredoff the ball to the bowler’s progressive figures. We show the W or W 1 againstthe batter to show what happened on the ball if we need to reconcile thebook. The batter is not credited with the wide or any runs scored off the ball,even though the bowler is, as described above.Wide balls are not counted as legal deliveries, and therefore must berebowled. If a bowler bowls one wide ball in an over, then that over willconsist of seven balls instead of the usual six, and if the bowler bowls twowide balls, the over will contain eight balls etc. A wide does NOT count as aball faced by the batter.An over which contains a wide cannot be a maiden over.No ballsA no ball can be called for a variety of reasons. The most common reason isthat the bowler has overstepped the popping crease when delivering the ball,but other reasons include a high full-pitched ball, the ball bouncing morethan twice before reaching the batter, and fielding infringements.When a no ball is signalled by the umpire and no other runs are scored, entera against the batter, 1 in the No ball section in sundries, 1 to theprogressive score and a in the bowler’s column. Don’t forget at the end ofthe over that the represents one run against the bowler and has to beadded to that bowler’s progressive bowling figures.No ball against batter No ball in No balls section No ball against bowlerWhen runs are scored from a no ball, enter the runs against the batter with acircle around them, enter 1 in the no ball column under sundries, add theruns plus 1 for the no ball penalty to the progressive score, and the runs witha circle around them in the bowler’s column. For example, if 4 runs arescored, show against the batter, 1 in the no ball column, add 5 to theprogressive score (4 runs plus penalty 1) and against the bowler (the circlemeans that 5 runs are added to the bowler’s tally). The reason to show only 4in a circle is so that if there is a dispute in the total runs scored, it is easier toQueensland Cricket Scorers Association35
Page 2: 2Demonstrated ability to:- devote m
Page 6: IntroductionEvery cricket team need
Page 9 and 10: Before the game startsEquipment req
Page 11 and 12: • Write down the details at the t
Page 13 and 14: Getting to know the playersOne of t
Page 15 and 16: FieldersIt is important to be able
Page 18 and 19: This means if an umpire must signal
Page 20 and 21: OutNew ballRevoking a callExtending
Page 22 and 23: Handy hintWatch for the unexpected
Page 24 and 25: Umpire to player signalsThe umpire
Page 26 and 27: Dot balls‘Dot ball’ is the phra
Page 28 and 29: called short, you will only record
Page 30 and 31: End of the overAt the end of each o
Page 32 and 33: When completing the bowling summary
Page 36 and 37: find all the 1s, 2s, 3s, 4s and 6s
Page 38 and 39: Batter 2 - Reed - has been bowled.
Page 40 and 41: the wicket. A red X is recorded in
Page 42 and 43: Because retirements have nothing to
Page 44 and 45: • Total the bowling figures.• C
Page 46 and 47: 2. DeclarationComplete your book as
Page 48 and 49: Handy hintA first innings win is ge
Page 50 and 51: You need to monitor the number of b
Page 52 and 53: MinutesTo be able to record batter,
Page 54 and 55: Example 2: Team A is batting first
Page 56 and 57: End of innings - ball going to boun
Page 58 and 59: come down the wicket and hit the st
Page 60 and 61: are statistic-mad. Most cricket clu
Page 62 and 63: As stated above, it can be very con
Page 64 and 65: Other things that you can use your
Page 66 and 67: • The umpire will always signal t
Page 68 and 69: The name of the batter who continue
Page 70 and 71: • Keep track of all individual de
Page 72 and 73: The match details are recorded at t
Page 74 and 75: was scored, so the total for that c
Page 76 and 77: • ability to calculate delays and
Page 78 and 79: a result of the match (e.g. Queensl
Page 80 and 81: including showing byes, leg byes an
Page 82 and 83: Sample running sheetsThis is the st
Page 84 and 85:
1123456789Sample scoresheets841. Ma
Page 86 and 87:
1243567861. Match details2. Age for
Page 88 and 89:
No ball ready reckonerUmpire who ma
Page 90 and 91:
TWENTY20 MATCHESCALCULATION OF TARG
Page 92 and 93:
○ ○ ○ ○ ○ ○ ○ ○ ○
Page 94 and 95:
no ball 17, 19, 22, 23, 25, 30,35,
show all

QCSA Handbook on scoring 2010 - Queensland Cricket

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?