QCSA Handbook on scoring 2010 - Queensland Cricket

More documents

Recommendations

Info

Batter 2 – Reed – has been bowled. His innings is marked off (>), the method ofdismissal and bowler’s name are recorded, and his runs, balls faced and boundaries aretotalled.Next complete the fall of wicket details.Record the team’s total runs at the fallof wicket, the name of the batter whowas out, and the name and score (in brackets) of the not out batter.In the bowler’s analysis, if the methodof dismissal is one that the bowler getscredit for (see the Wickets readyreckoner on page 42 to determine if thebowler gets credit for the wicket), marka red X in the analysis.In most other cases, where the bowler does not get credit for the wicket,place a dot in the bowler’s analysis, although there are exceptions to this,including run outs (see If a batter is run out below), and methods ofdismissal that happen ‘between balls’ (e.g. retirement and timed out),where you will record nothing against the bowler.If you and your fellow scorer are unsure of how the batter was out, pencil inthe method you believe is correct, and check with the umpires at the nextbreak.After all this is complete, add the incoming batter to the scorecard and youare ready to start again.If a batter is run outWhen a batter is run out, the striker will be credited with the runsCOMPLETED before the dismissal. If the batters are going for the first run,no runs are recorded. If they are going for their second or third run, theCOMPLETED runs are credited to the batter, added to the total score andshown against the bowler. Therefore, if a player is run out going for thethird run, the 2 completed runs are awarded to the striker, 2 runs are addedto the total score and 2 runs are recorded against the bowler.38Queensland Cricket Scorers Association
You can then proceed to record the wicket. The batter is shown as Run out.Record the fielders involved in the run out in brackets against the batter.In the case above, two fielders were involved in the run out. White fielded the ball, andthrew it to Creedon, who removed the bails with it. If White’s throw had hit the stumpsand removed the bails without assistance, only White’s name would appear on thescoresheet.The bowler’s name is not recorded as the bowler is not credited with thewicket. You could show the symbol R in the bowler’s analysis to denote whenthe run out occurred. If there were completed runs, the completed runs areshown in the bowler’s analysis, and you could add an R above the runs toindicate the run out (i.e. 2 R) .Handy hintIf a batter gets out two ways (and it can happen — e.g. caught and hitwicket), record the method of dismissal that occurred first. Butremember that bowled takes precedence over other methods. In arecent Test, the umpire was in the process of giving Shane Watson outlbw when the ball rolled onto the stumps. Therefore, Watson was outbowled, not lbw.If a batter is caught outWhen a batter is caught out, no runs are scored under any circumstances(Rule 32).The name of the person who took the catch should always be shown, as itcould be needed for trophies at the end of the season. If the name of thecatcher is unknown, you should check with the captain of the fielding team atthe next break. The bowler’s name is recorded, as the bowler is credited withQueensland Cricket Scorers Association39
Page 2: 2Demonstrated ability to:- devote m
Page 6: IntroductionEvery cricket team need
Page 9 and 10: Before the game startsEquipment req
Page 11 and 12: • Write down the details at the t
Page 13 and 14: Getting to know the playersOne of t
Page 15 and 16: FieldersIt is important to be able
Page 18 and 19: This means if an umpire must signal
Page 20 and 21: OutNew ballRevoking a callExtending
Page 22 and 23: Handy hintWatch for the unexpected
Page 24 and 25: Umpire to player signalsThe umpire
Page 26 and 27: Dot balls‘Dot ball’ is the phra
Page 28 and 29: called short, you will only record
Page 30 and 31: End of the overAt the end of each o
Page 32 and 33: When completing the bowling summary
Page 34 and 35: Leg bye against batterLeg bye in Le
Page 36 and 37: find all the 1s, 2s, 3s, 4s and 6s
Page 40 and 41: the wicket. A red X is recorded in
Page 42 and 43: Because retirements have nothing to
Page 44 and 45: • Total the bowling figures.• C
Page 46 and 47: 2. DeclarationComplete your book as
Page 48 and 49: Handy hintA first innings win is ge
Page 50 and 51: You need to monitor the number of b
Page 52 and 53: MinutesTo be able to record batter,
Page 54 and 55: Example 2: Team A is batting first
Page 56 and 57: End of innings - ball going to boun
Page 58 and 59: come down the wicket and hit the st
Page 60 and 61: are statistic-mad. Most cricket clu
Page 62 and 63: As stated above, it can be very con
Page 64 and 65: Other things that you can use your
Page 66 and 67: • The umpire will always signal t
Page 68 and 69: The name of the batter who continue
Page 70 and 71: • Keep track of all individual de
Page 72 and 73: The match details are recorded at t
Page 74 and 75: was scored, so the total for that c
Page 76 and 77: • ability to calculate delays and
Page 78 and 79: a result of the match (e.g. Queensl
Page 80 and 81: including showing byes, leg byes an
Page 82 and 83: Sample running sheetsThis is the st
Page 84 and 85: 1123456789Sample scoresheets841. Ma
Page 86 and 87: 1243567861. Match details2. Age for
Page 88 and 89:
No ball ready reckonerUmpire who ma
Page 90 and 91:
TWENTY20 MATCHESCALCULATION OF TARG
Page 92 and 93:
○ ○ ○ ○ ○ ○ ○ ○ ○
Page 94 and 95:
no ball 17, 19, 22, 23, 25, 30,35,
show all

QCSA Handbook on scoring 2010 - Queensland Cricket

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?