SERVICE MANUAL - Nilfisk-Advance

More documents

Recommendations

Info

ENGLISH SERVICE MANUALDETERGENT SUPPLY SYSTEMTROUBLESHOOTINGSmall amount of solution or no solution reaches the brushPossible causes:1. The solution tank valve is clogged/dirty or broken (clean or replace).2. The solenoid valve (EV) is broken or there is an open in the electrical connection (replace the solenoid valve/repair theelectrical connection).3. There is debris in the solution tank clogging the output hole (clean the tank).4. There is debris in the solution hoses and/or reducer clogging the flow (clean the hose).The solution reaches the brush also when the machine is offPossible causes:1. There is dirt or calcium deposit on the solenoid valve gasket (clean).2. The solenoid valve is broken (replace).WIRING DIAGRAMP10042112 9098840000 SC350
BRUSHING SYSTEMBRUSH MOTOR ELECTRICAL INPUT CHECKWARNING!This procedure must be performed by qualified personnel only.SERVICE MANUALENGLISHBRUSHING SYSTEM1.2.3.Drive the machine on a level floor.Remove the brush, as shown in the User Manual.Place two wooden shims (A) under the side area of the deck as shown in the figure. Wooden shim thickness must be 40 mm.WARNING!Keep the wooden shims at an appropriate distance from the brush hub.4.5.6.7.8.Turn the knob (32) to program (34).Apply the amperometric pliers (A) on one cable (B) of the brush motor.Turn on the brush by pressing the push-button (39) together with the levers (40), then check that the motor electrical input (C)is:• 6 to 8 A at 12VTurn off the brush by releasing the levers (40).Turn the knob (32) to “0”.Remove the amperometric pliers (A).If the electrical input is higher, perform the following procedures to detect and correct the abnormal input:• Check if there is dust or dirt (ropes, cables, etc.) on the brush hubs.• Disassemble the motor (see the procedure in the relevant paragraph), and check the condition of all its components.If the above-mentioned procedures do not lead to a correct electrical input, the motor must be replaced (see the procedure inthe relevant paragraph).ABCP100422SC350 9098840000 13
Page 1: SC350SERVICE MANUAL9098840000Editio
Page 4 and 5: ENGLISHSERVICE MANUAL2 9098840000 S
Page 6 and 7: ENGLISHGENERAL INFORMATIONSERVICE M
Page 8 and 9: ENGLISH SERVICE MANUALGENERAL INFOR
Page 16 and 17: ENGLISHBRUSHING SYSTEMSERVICE MANUA
Page 18 and 19: ENGLISHBRUSHING SYSTEMTROUBLESHOOTI
Page 20 and 21: ENGLISHSERVICE MANUALRECOVERY WATER
Page 22 and 23: ENGLISHOTHER SYSTEMSOTHER SYSTEMSSE
Page 24 and 25: ENGLISH SERVICE MANUALELECTRICAL SY
Page 26: setting standardsNilfisk-Advance Sp

SERVICE MANUAL - Nilfisk-Advance

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?