VULCAN Pool Heater - Poolstore

Note: In some cases the high limit thermostat tripping and a low flowrate can be linked ie: when a filter becomes choked air can be drawninto the filtration system and become trapped inside the heater socausing the thermostat to trip.ENGLISHTrouble Shooting – DigitalHEATER WILL NOT SWITCH FROM STANDBY (AMBER LIGHT ) TO ON(RED LIGHT)In most cases this will be the result of one of the following points notbeing met.Possible cause 1: The set point temperature has been achieved.To confirm that the digital thermostat is requesting the unit to heat, see ifthere is an illuminated dot above the word ’Out’ on the digital thermostatdisplay (see fig 9) If illuminated go to step 2, if not illuminated raise therequired temperature to a value higher than the current water temperature.Confirm whether the heater now switches to ’Heat on’ mode (redlight)If continuously illuminated:Indicates that the currentwater temperature hasfallen below the requiredtemperature.If flashing:Indicates that the unit is in‘Time delay’ mode.Fig 9.Possible cause 2: The high limiting thermostat has tripped.Remedy: Remove button cover and press red button to re-set (see fig 8)If a positive click is felt, the cause of the tripping must be investigated andcould be caused by a debris build-up or air pocket trapped inside the flowtube of the heater.Possible cause 3: Insufficient flow.Remedy: If the display is flashing ‘noFL’ the flow rate has dropped belowthe minimum level or has stopped completely. The cause of the reduced /static flow rate should be investigated and resolved.11