Untitled - Usinages

DESCRIPTIONCODEKnurling toolholder, adjustable, maximum knurling length 1*' ..Roller steady box, tangential cutting, maximum turning diameterjl", maximum turning length 1f", minimum steady diameterf' ,.Floating holder, lor reamers etc. bored |' diameterCut-otr Slide - lever operated with front and rear tool posts,eqch having tee slot adjustment, gives provision lor both partingoff and forming. Adjustable stops are provided for both lrontand reartools, Maximum stroke 3n (75mm), maximum swing overslide 2f" (70mm). Tool section $" (10mm) square8A604590A20/088Turret attachment for mounting on the cross-slide. All thetooling listed above for 20/068 can be utllised in conjunction withthis attachment. Excluding tools illustrated .. ..t{08Multi-stop, for use with No. 1408 turret attachment is bolted onto the back of the bed, and to the saddle, beneath the rear strip.Six length stops are provided which can prove a useful facillhTfor normal turning independent of the turret. Maximum strok64*" (114mm), stop screw adjustment 2" (50mm)l{83t610The lever operated tailstock attachment, can readily be interchangedwith the standard handwheel and barrel whenever anumber of components has to be drilled or centred. An ad-justable stop is fitted for accurate depth control. Maximumstroke 2*' (57mm)milling equipment6?/r30/0t1Vertical slide, plain type is attached to the cross-slide by meansof two tee bolts. The slide table is 5|' (13ilmm) x 2f' (70mm), thefeedscrew is 10 T.P.l. and is fitted with a mlcrometer dial with0.fi)1' graduations. Table provided with two clamping screws.Slide movement, with table facing headstock spindle 3t'(82mm). Also available with 2mm pitch feed screw and 0.02mmgraduationsVertical slide, swivelling type, is attached to the cross-slide bymeans of two tee bolts and is arranged to pivot in both verticaland horizontal planes. The angle bracket which has large areacontact faces for maximum rigidity is graduated for bothmovements. The table size is 5' (127mm) x 4' (101mm) and thefeedscrew is fitted with a micrometer dial having 0.fi)l' graduations.Table provided with two clamping screws, Slide movement,with table facing headstock spindle, 3' (76mm). Alsoavailable with 2mm pitch feed screw and 0.02mm graduations.Raising block,2{" (54mm) high, for 6711 and 68/2 vertical slide;increases versatility also capacity of 1495 dividing attachment.(Can also be used at rear ol cross-slide)67lril1230/0llDividing attachment is arranged for mounting on to either the6/1 plain or 68/2 swivelling vertical slide. lt is complete with twodivision plates covering all numbers up to 50 and all evennumbers up to 100 excepting 88. Many numbers above 100 canalso be obtainedt495Extra plates (2) cover No.88 and allthe remaining odd numbersup to 100 palr 1471