HUBER+SUHNER SENCITY RAIL ANTENNA - Nkt-rf.ru

HUBER+SUHNER ®SENCITY ® RAIL ANTENNAMounting InstructionKeep away from catenary and high voltage lines.Be careful when working at height!Always secure ladders!Always tighten screws!Dimensions in millimetre [mm]Mounting surfaceThe area of the roof where the antenna ismounted has to be planar and stable.Mounting surfaceDrilling of boreholes1. Drilling of hole for connector2. Use the antenna as hole-gauge3. Drilling of the four mounting holesØ38 … Ø56Preparation of roof1. Clear the area, where the antenna ismounted from paint, corrosion or anyanodized layer.2. Clear this area from any dust, brakedust, cutting chip, oil or fat.Installation on bracket: Mounting of cable conduit and grounding kitFor protecting the cables an additional cableprotection kit can be mounted to the antenna(e.g. antenna mounting on a bracket). Ourconduit support kit (Art. no. 84079593) allowsthe use of standard M40x1.5 conduit guides.Please refer to mounting instruction of article84079593.For the connection of a grounding cable, anadditional grounding kit can be mounted.Please refer to the mounting instruction ofarticle 84079030Page 1 of 2

Top side mountingBottom side mountingMin. Ø 8.5M8 (21Nm) see 1)M8 (18Nm)1) For a minimum 8 mm thick steel plate.SealingSealingAntennaThe four screw enclosuresmust be sealed usingthe appropriate sealing.The whole perimeter of the antennacould be sealed at this position.Using the appropriate sealing.6Dimension X: Length of screw=Mounting surface thickness + 8.5mm±1mmAntennaThe whole perimeter of theantenna could be sealed atthis position. If the antennais not secured by four M8screws, the whole perimeterof the antenna has to be sealed.Using the appropriate sealing.XMounting surfaceMounting surfaceConnection of cablesSatellite signal1.0Nm0.6NmGeneral remarksIn the final position of the antenna, the draining hole and the connectors need to be protected against environmental impacts (indoorenvironment). Otherwise a manufacturer’s suggested protection kit has to be used.For more information, please refer to the installation manual which can be found on our homepage onhttp://www.hubersuhner.com/products/hs-p-rf/hs-rf-antennas/hs-m-rail-ant-rail/hs-p-rf-ant-lightrail.htmHUBER+SUHNER is certified according to ISO 9001 and ISO 14001WAIVER!It is exclusively in written agreements that we provide our customers with warrants andrepresentations as to the technical contained specifications and/or the fitness for anyparticular purpose. The facts and figures herein are carefully compiled to the best of ourknowledge, but they are intended for general informational purposes only.HUBER+SUHNER – Excellence in Connectivity SolutionsHUBER+SUHNER AGRF Technology9100 Herisau, SwitzerlandPhone +41 (0)71 353 41 11Fax +41 (0)71 353 47 51www.hubersuhner.comDoc. No. 0000295392Art. No. 84078802Revision FPage 2 of 2