User Manual - Stryker Restep DVT System

More documents

Recommendations

Info

EMC GUIDANCE AND DECLARATIONSThe following EMC Guidance and Declarations refer to the <strong>Restep</strong> ® <strong>DVT</strong> system.Guidance and manufacturer’s declaration – electromagnetic emissionsThis device is intended for use in the electromagnetic environment specified below. The customer or theuser of the device should assure that it is used in such an environment.Emissions test Compliance Electromagnetic environment – guidanceRF emissionsCISPR 11Group 1This device uses RF energy only for its internalfunction. Therefore, its RF emissions are very lowand are not likely to cause any interference innearby electronic equipment.RF emissionsCISPR 11Harmonic emissionsIEC 61000-3-2Class BClass AThis device is suitable for use in allestablishments, including domesticestablishments and those directly connected tothe public low-voltage power supply network thatsupplies buildings used for domestic purposes.Voltage fluctuations/flicker emissionsIEC 61000-3-3Complies20
Guidance and manufacturer’s declaration – electromagnetic immunityThis device is intended for use in the electromagnetic environment specified below. The customer or theuser of this device should assure that it is used in such an environment.Immunity test IEC 60601test levelElectrostaticdischarge (ESD)IEC 61000-4-2Electrical fasttransient/burstIEC 61000-4-4SurgeIEC 61000-4-5Interruptions andvoltage variationson power supplyinput linesIEC 61000-4-11±6 kV contact±8 kV air±2 kV for powersupply lines±1 kV for input/output lines±1 kV line(s) toline(s)±2 kV line(s) toearth95 % dip in UT)for 0,5 cycle40 % UT(60 % dip in UT)for 5 cycles70 % UT(30 % dip in UT)for 25 cyclesCompliance level Electromagnetic environment –guidance±6 kV contact±8 kV air±2 kV for powersupply lines±1 kV for input/outputlines±1 kV line(s) to line(s)±2 kV line(s) to earth95 % dip in UT)for 0,5 cycle40 % UT(60 % dip in UT)for 5 cycles70 % UT(30 % dip in UT)for 25 cyclesFloors should be wood, concreteor ceramic tile. If floors arecovered with synthetic material,the relative humidity should be atleast 30%.Mains power quality should be thatof a typical commercial or hospitalenvironment.Mains power quality should be thatof a typical commercial or hospitalenvironment.Mains power quality should bethat of a typical commercial orhospital environment. If the userof the device requires continuedoperation during power mainsinterruptions, it is recommendedthat this device be powered froman uninterruptible power supply ora battery.Power frequency(50/60 Hz)magnetic fieldIEC 61000-4-895 % dip in UT)for 5 sec.3 A/m 3 A/m95 % dip in UT)for 5 sec.Power frequency magneticfields should be at levelscharacteristic of a typical locationin a typical commercial or hospitalenvironment.NOTE UT is the a.c. mains voltage prior to application of the test level.21
Page 1 and 2: Deep Vein Thrombosis(DVT) SystemUse
Page 4 and 5: INTRODUCTIONThis manual should be u
Page 6 and 7: EMC WarningThis product complies wi
Page 8 and 9: GarmentsAll Restep ® DVT garments
Page 10 and 11: Charging the battery (continued)NOT
Page 12 and 13: Bariatric Calf GarmentsThe bariatri
Page 14 and 15: 1. Power SwitchPress the Power Swit
Page 16 and 17: Garment MODE selectionThe two modes
Page 18 and 19: TROUBLESHOOTINGProblemsSolutions•
Page 20 and 21: MAINTENANCEGeneralThe Restep ® sys
Page 24 and 25: Guidance and manufacturer’s decla
Page 26 and 27: 24NOTES:
Page 28: MANUFACTURED FOR1810 West Drake Dri

User Manual - Stryker Restep DVT System

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?