SSG-4000LH USB Synthesized Signal Generator - Mini-Circuits
SSG-4000LH USB Synthesized Signal Generator - Mini-Circuits
SSG-4000LH USB Synthesized Signal Generator - Mini-Circuits
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>USB</strong> <strong>Synthesized</strong> <strong>Signal</strong> <strong>Generator</strong><strong>SSG</strong>-<strong>4000LH</strong>Electrical Specifications (Pulse modulation modes) 6 at +25°CParameter Test Conditions Min. Typ. Max. UnitsPulse Width resolution Nominal value 1 − µSecPulse Period Measured at the 50% points 2 µSec − 10 Sec −Duty cycle 7 Pulse Width divided by Pulse Period 0.01 − 99.99 %Rise / Fall time Measured between 10% and 90% − 30 / 45 − nSecPulse Width Accuracy Measured at the 50% points − ±2 − %Trigger response delay 8,9 Relevant trigger edge to 50% point of the pulse − 3.5 − µSecPulse Power ratio @PWR OUT =+20dBm, FREQ OUT =250 MHz − 60 −Pulse Power ratio @PWR OUT =+17dBm, FREQ OUT =4000 MHz − 50 −6 Pulse mode is supported from Firmware Rev. B3. Firmware from Rev. B1 onwards can be upgraded using the latest software CD (available for downloadfrom http://www.minicircuits.com/support/software_download.html7 In Free Run mode.8 Max trigger frequency is 200 kHz9 In Triggered mode the <strong>SSG</strong>-<strong>4000LH</strong> can be triggered by either rising edge or falling edge as selected by the customer using the supplied software.Electrical Specifications at +25°C (Reference, Trigger & DC power)Parameter Test Conditions Min. Typ. Max. UnitsAging Using Internal Reference − 1 − ppm/yrReference InReference OutFrequency − − 10 − MHzPower − -3.5 − +7.5 dBmFrequency − − 10 − MHzFreq. Accuracy Using Internal Reference − ±1 − ppmPower − − +7 − dBmAging Using Internal Reference − 1 − ppm/yrTrigger Out, Low − 0 − 0.4Trigger Out, High − 2.4 − 3.3Trigger In, Low − 0 − 0.8Trigger In, High − 2.4 − 3.3Supply Voltage 10 − 22.8 24 25.2 V DCSupply Current 10 − − 400 500 mA<strong>USB</strong> current 10 − − Note 11 − mA10 Power On Sequence: Connect the 24V power, followed by the <strong>USB</strong> control before turning on the <strong>Generator</strong>11 <strong>SSG</strong>-<strong>4000LH</strong> does not draw power from the <strong>USB</strong> bus, only from DC power adapter<strong>Mini</strong>mum System RequirementsInterfaceHost operating systemHardware<strong>USB</strong> HID32 Bit operating system: Windows 98 ® , Windows XP ® ,Windows Vista ® , Windows 7 ® , Windows 8 ®64 Bit operating system: Windows Vista ® , Windows 7 ® ,Windows 8 ®Linux ® support: 32/64 Bit operating systemPentium ® II or betterdBVAbsolute Maximum RatingsOperating TemperatureStorage TemperaturePower in @ Reference InReverse Power(DC) @ Reference OutReverse Power(DC) @ RF OutVoltage @ Trigger outVoltage @ Trigger inPermanent damage may occur if any of these limits are exceeded.0ºC to +50ºC-20ºC to +60ºC+10 dBm25V DC10V DC-0.3V DC to +3.5V DC-0.3V DC to +3.5V DCConnectionsRF Output(N Type-Female)Ref. In(BNC-Female)Ref. Out(BNC-Female)Trigger In(BNC-Female)Trigger Out(BNC-Female)Power In (2.1 mm DC socket)<strong>USB</strong> Port (<strong>USB</strong> B female)<strong>Mini</strong>-<strong>Circuits</strong> ®www.minicircuits.com P.O. Box 35166, Brooklyn, NY 11235-0003 (718) 934-4500 sales@minicircuits.comPage 4 of 9
<strong>USB</strong> <strong>Synthesized</strong> <strong>Signal</strong> <strong>Generator</strong><strong>SSG</strong>-<strong>4000LH</strong>Typical Performance Curves**at +25°C unless mentioned otherwiseOutput Power (dBm)201816141210Max. Power OutputVs. Output Frequency0 C+25 C+50 CHarmonics (dBc)-15-35-55-75-95Harmonics & Sub-Harmonics LevelsVs. Output Frequency PWR=-50dBmF2 F3 F0 5 F1.5 F2 58250 1000 1750 2500 3250 4000Output Frequency (MHz)115250 1000 1750 2500 3250 4000Output Frequency (MHz)-15Harmonics & Sub-Harmonics LevelsVs. Output Frequency PWR=-30dBmF2 F3 F0.5 F1 5 F2.5-15Harmonics & Sub-Harmonics LevelsVs. Output Frequency PWR=-10dBmF2 F3 F0.5 F1 5 F2.5-35-35Harmonics (dBc)-55-75Harmonics (dBc)-55-75-95-95115250 1000 1750 2500 3250 4000Output Frequency (MHz)115250 1000 1750 2500 3250 4000Output Frequency (MHz)-15Harmonics & Sub-Harmonics LevelsVs. Output Frequency PWR=0dBmF2 F3 F0 5 F1.5 F2.5-15Harmonics & Sub-Harmonics LevelsVs. Output Frequency PWR=+10dBmF2 F3 F0 5 F1 5 F2.5-35-35Harmonics (dBc)-55-75Harmonics (dBc)-55-75-95-95115250 1000 1750 2500 3250 4000Output Frequency (MHz)115250 1000 1750 2500 3250 4000Output Frequency (MHz)<strong>Mini</strong>-<strong>Circuits</strong> ®www.minicircuits.com P.O. Box 35166, Brooklyn, NY 11235-0003 (718) 934-4500 sales@minicircuits.comPage 5 of 9
<strong>USB</strong> <strong>Synthesized</strong> <strong>Signal</strong> <strong>Generator</strong><strong>SSG</strong>-<strong>4000LH</strong>Typical Performance Curves* (continued)*at +25°C unless mentioned otherwise-60Phase Noise Vs. Frequencyat 5kHz Freq. Resolution-60Phase Noise Vs. Frequencyat 1MHz Freq. ResolutionPhase Noise (dBc Hz)Phase Noise (dBc/Hz) ( )-80-100-120-140100Hz 1KHz 10kHz 100kHz 1MHz-160250 1000 1750 2500 3250 4000Output Frequency (MHz)-50-70-90-110-130Phase Noise over Frequenciesat 5kHz Freq. Resolution250 MHz1060 MHz2600 MHz4000 MHzPhase Noise (dBc/Hz) Phase Noise (dBc/Hz)-80-100-120-140100Hz 1KHz 10kHz 100kHz 1MHz-160250 1000 1750 2500 3250 4000Output Frequency (MHz)-50-70-90110130Phase Noise over Frequenciesat 1MHz Freq. Resolution250 MHz1060 MHz2600 MHz4000 MHz-1501500.1 1.0 10.0 100.0 1000.00.1 1.0 10.0 100.0 1000.0Frequency Offset (kHz) Frequency Offset (kHz)Pulse mode definitionsPULSE WIDTHPULSE PERIODPULSE "ON"90% POINT50% POINT10% POINTPULSE "OFF"RISE TIMEFALL TIME<strong>Mini</strong>-<strong>Circuits</strong> ®www.minicircuits.com P.O. Box 35166, Brooklyn, NY 11235-0003 (718) 934-4500 sales@minicircuits.comPage 7 of 9
<strong>USB</strong> <strong>Synthesized</strong> <strong>Signal</strong> <strong>Generator</strong><strong>SSG</strong>-<strong>4000LH</strong>Ordering, Pricing & Availability Information see our web siteModel<strong>SSG</strong>-<strong>4000LH</strong>Description<strong>USB</strong> <strong>Synthesized</strong> <strong>Signal</strong> <strong>Generator</strong>Included Accessories Part No. DescriptionAC/DC-24-3W1AC/DC 24V DC Grounded Power Adaptor.Operating temperature: 0°C to +40°C, I Max =2.5ACBL-3W1-XXAC Power Cord (Select one power cord from below witheach <strong>Signal</strong> <strong>Generator</strong>)<strong>SSG</strong>-CDSoftware CD<strong>USB</strong>-CBL-AB-3+2.7 ft (0.8 m) <strong>USB</strong> Cable: <strong>USB</strong> type A(Male) to <strong>USB</strong>type B(Male)AC Power Cords 13 Part No. DescriptionCBL-3W1-USPower Cord for United StatesCBL-3W1-EUPower Cord for EuropeCBL-3W1-UKPower Cord for United KingdomCBL-3W1-AUPower Cord for Australia and ChinaCBL-3W1-ILPower Cord for Israel11. Power cords for other countries are also available, if you need a power cord for a country not listed in the table please contactapps@minicircuits.com or check http://www.minicircuits.com/contact/offices.html for regional offices e-mail and phone numbers.Optional Accessories<strong>USB</strong>-CBL-AB-3+ (spare)<strong>USB</strong>-CBL-AB-7+<strong>USB</strong>-CBL-AB-11+BKT-280-06+Description2.7 ft. (0.8 m) <strong>USB</strong> cable6.8 ft. (2.1 m) <strong>USB</strong> Cable11 ft. (3.4 m) <strong>USB</strong> CableBracket (One set of 2 each)CalibrationDescriptionCAL<strong>SSG</strong>-<strong>4000LH</strong> Calibration Service Click HereAdditional NotesA. Performance and quality attributes and conditions not expressly stated in this specification document are intended to be excluded and do not form a part of thisspecification document.B. Electrical specifications and performance data contained in this specification document are based on <strong>Mini</strong>-Circuit’s applicable established test performance criteria andmeasurement instructions.C. The parts covered by this specification document are subject to <strong>Mini</strong>-<strong>Circuits</strong> standard limited warranty and terms and conditions (collectively, “Standard Terms”);Purchasers of this part are entitled to the rights and benefits contained therein. For a full statement of the Standard Terms and the exclusive rights and remediesthereunder, please visit <strong>Mini</strong>-<strong>Circuits</strong>’ website at www.minicircuits.com/MCLStore/terms.jsp<strong>Mini</strong>-<strong>Circuits</strong> ®www.minicircuits.com P.O. Box 35166, Brooklyn, NY 11235-0003 (718) 934-4500 sales@minicircuits.comPage 9 of 9
Change language