Instruction Manual - Amron International Inc.

More documents

Recommendations

Info

CONTROLS & CONNECTIONSDRAWING, OPERATOR CONNECTIONS, HEADSET 5.1115
INSTALLATION & OPERATIONOPERATION 6.1The Model 2830R/24/XX AMCOM III rack mount diver communicator is designed to mount in astandard electronic equipment rack, 19 inches wide. The unit has connections located on both thefront and rear of the enclosure, to facilitate system wiring. For system installation all connectionscan be made to the rear of the unit, eliminating wires hanging from the front panel.The AMCOM III panels are graphically divided into sections; Tender Controls, Diver Controls, andOptions. Items within these areas are functions or controls relating to the Tender, Diver(s) orOptional items.AC POWER 6.2When the unit is connected to AC power the LED power indicator on the STATUS section of the frontpanel will illuminate, confirming the presence of AC power.The AMCOM III is designed to operate from AC voltage (110/220 VAC 60/50 Hz). This optionincludes two 6 volt gel cell batteries (connected in series for 12 VDC) for backup operation in theevent of loss of AC power. The switch over to battery operation is completely automatic, and occurswhenever AC power is interrupted. The internal rechargeable battery is maintained at full chargewhile the unit is operating from AC power. AC power indicator on the optional panel confirms thepresence of AC power.CAUTION: ALWAYS exercise extreme caution when operating portable AC powered equipment,especially when outdoors, where conditions are damp or wet, or when around other equipment.Never operate unit without earth-ground or without a working ground fault interrupter. When indoubt discontinue use immediately and have a qualified electrician inspect your equipment beforeusing.WARNING: All AC powered equipment should be used with a ground fault interrupter. All groundfault interrupters have a built in test circuit, check for proper operation before using.NOTE: Do not continue to operate rechargeable batteries below the low battery condition orpermanent damage will occur. When the battery condition indicator turns to red color, shut unit offand charge batteries16
Page 1 and 2: User ManualForAmron International D
Page 3 and 4: TABLE OF CONTENTSTheory of Operatio
Page 5 and 6: GENERAL INFORMATIONGENERAL INFORMAT
Page 7 and 8: GENERAL INFORMATIONDRAWING FRONT PA
Page 9 and 10: WARRANTYLIMITED WARRANTY 4.1AMRON I
Page 11 and 12: CONTROLS & CONNECTIONSTENDER CONNEC
Page 13 and 14: CONTROLS & CONNECTIONSOPTIONS 5.7CA
Page 15 and 16: CONTROLS & CONNECTIONSDRAWING, 2-WI
Page 17: CONTROLS & CONNECTIONSDRAWING, OPER
Page 21 and 22: INSTALLATION & OPERATIONMODES OF OP
Page 23 and 24: INSTALLATION & OPERATIONVOLUME CONT
Page 25 and 26: INSTALLATION & OPERATIONOPTIONS 6.1
Page 27 and 28: INSTALLATION & OPERATIONSIMULCOM -
Page 29 and 30: INSTALLATION & OPERATIONSIMULCOM -
Page 31 and 32: THEORY OF OPERATIONTHEORY OF OPERAT
Page 33 and 34: THEORY OF OPERATIONOPTION /26DSP2 H
Page 35 and 36: MAINTENANCEDIVER RADIO FIELD CHECK
Page 37 and 38: MAINTENANCEPROBLEMS AND THEIR POSSI
Page 39 and 40: DRAWINGS & SCHEMATICSGeneral 9.1The
Page 41 and 42: DRAWINGS & SCHEMATICSSCHEMATIC OPTI
Page 43 and 44: DRAWINGS & SCHEMATICSSCHEMATIC 4002
Page 45 and 46: DRAWINGS & SCHEMATICSPARTS IDENTIFI
Page 47 and 48: DRAWINGS & SCHEMATICSPARTS IDENTIFI
Page 49 and 50: PARTS LISTAMCOM III RACKMOUNT MODEL
Page 51 and 52: PARTS LISTSUB ASSEMBLY 2830R/26-400
Page 55: PARTS LIST28XXR-FS SPARES KIT FOR 2

Instruction Manual - Amron International Inc.

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?