Vivotek IP7361 Installation Guide - Use-IP

More documents

Recommendations

Info

EnglishWaterproof ConnectorComponents of the Waterproof ConnectorScrew Nut (A)Seal (B)Seals (C)Housing (D)Sealing Nut (E)Pin Definition1 2 3 4 5 6 7 843211 Power +12V2 Digital Output3 Digital Input4 Ground5 AC 24V6 AC 24V7 RS485 +8 RS485 -1 External MIC In2 Ground3 Audio Out4 GroundAssembling Steps1. Disassemble the components of the waterproof connector into part (A) ~ (E) as shown above.2. Open the back cover of the Network Camera.3. Remove the rubber stopper from the bottom of the Network Camera and secure the screw nut (A)tightly.4. If you need extra power for external devices, please feed the power cable through the wall mountbracket and the waterproof connector (E --> D --> B --> A) as the illustration shown below. Thenconnect the power cord to the socket. Note: There are 7 holes on the seal (B), and the widest holewith a crack on the side is specific for power cord.5. If you have external devices such as sensors and alarms, feed the cables through the wall mountbracket and the waterproof connector (E --> D --> B --> A) as the illustration shown below. Thenrefer to the pin definition to connect them to the general I/O terminal block. Note: The recommendedcable gauge is 2.0 ~ 2.8 mm.6. Push the seal (B) into the housing (D).7. Insert the seals (C) into the empty holes on the seal (B) to avoid moisture.8. Secure the sealing nut (E) tightly.573(A)(B)(B)6(D)(C)(D)(E)448(E)EN-5
4Cabling AssemblyRJ45 Cable ConnectorRJ45 Cable Dimension (unit: mm)Components of the WaterproofConnectorSealing Nut (A)Seal (B)Screw Nut (C)Housing (D)Gasket (E)Assembling Steps1 Prepare an Ethernet cable2 Insert the housing into the3and strip part of the sheath.screw nut.Insert the seal into the housing.(C)(D)(B)Recommended cable gauge: 24AWG(0.51 mm)4 Insert the stripped Ethernet5 Clamp the cable with6cable through the sealingan RJ45 plug.nut and the housing.(A)Push the RJ45 plug into thehousing, then secure thesealing nut tightly.7 Attach the gasket to the front 8of the housing.(E)Connect the Ethernet cable to the RJ45 cable and secure theconnectors tightly.EN-6
Page 2 and 3: EnglishWarning Before InstallationP
Page 4 and 5: English2Physical DescriptionIR LEDL
Page 9 and 10: 6Assigning an IP Address1. Install

Vivotek IP7361 Installation Guide - Use-IP

Create successful ePaper yourself

Delete template?

Save as template?