Power Jack Gamma With Ceramic Metal Halide T4 - Tech Lighting

Installation Instructions forPower Jack Gamma With Ceramic Metal Halide T4700PJGMT4_920PJGMT451.9HEADS-LINE VOLTAGEGENERAL PRODUCT INFORMATION:This product is suitable for indoor dry locations only.This product is intended for use only with Tech LightingPower Jack & T~trak systems.This product is patented (U.S. PAT. 7,172,133).Installing the Lamp1A1B#6-32 SCREWLAMPSOCKET1124GLASS SCREEN DOORUse 120 Volt, 20 Watt Ceramic MetalHalide T4.5 Lamp with 700PJGMT4_2_ Models.NOTE: Turn off power to the system beforeinstalling, removing, or relamping the fixture.Use 120 Volt, 39 Watt Ceramic MetalHalide T4.5 Lamp with 700PJGMT4_3_ Models.1Loosen (Do Not Remove) the two #6-32 screws on thefront of the glass screen door with a Phillips screwdriver.Use 120 Volt, 70 Watt Ceramic MetalHalide T4.5 Lamp with 700PJGMT4_7_ Models.2Carefully open the glass screen.NOTE: Use only your fingers and a soft cloth toreplace the lamp.34Handle the new replacement lamp with a soft cloth toprevent the natural oils on the fingertips from collectingon the lamp. This will help extend the life of the lamp.Push the lamp pins completely into the socket holes.1

1C#6-32 SCREWIMPORTANT SAFETY INSTRUCTIONSTo reduce the risk of fire, electrical shock, exposure toexcessive UV radiation, or injury to person:– Use this fixture indoors only.51– Do not look directly at the lighted lamp.– Do not remain in light if skin feels warm.– Risk of fire: Use only the type of lamp and maximumwattage indicated in this instruction manual.– Never cover the halogen lamp with anything other than aTech Lighting lamp shield and never place flammablematerial close to your fixture.GLASS SCREEN– Never turn the fixture on and off by connecting anddisconnecting the halogen lamp.5Close the glass screen and tighten the two #6-32 screwswith a Phillips screwdriver.SPECIAL INSTALLATION:Locking the Fixture in PermanentPosition (Optional)2A– Do not touch the fixture shades or lamp shield while thefixture is on. These surfaces may be HOT.Halogen Lamp General Information– A new halogen lamp may smoke slightly when it is usedfor the first time. This is perfectly normal; the protectivecoating is simply being vaporized.Two Tips For Prolonging HalogenLamp Life– First avoid touching the lamp with bare hands duringinstallation. Any contaminant, even the oil from yourhands can deteriorate the lamp. Rubbing alcohol can beused to remove any contaminant.1– Second, do not run the lamps at full power when you donot need to. However, if dimming the fixture for anextended period of time, occasionally bring the light up tofull brightness for a few minutes to complete the halogencycle.2 3#6-32 SET SCREWSAVE THESE INSTRUCTIONS!1/16 ALLEN WRENCH123To lock the fixture head in a permanent vertical position,loosen (DO NOT REMOVE) the #6-32 set screw oncylindrical connector with the provided 1/16 Allenwrench.Rotate the fixture head to the desired position.Tighten the #6-32 set screw with the 1/16 Allen wrench.a brand of7400 Linder Ave, Skokie, IL 60077847.410.4400www.ttraklighting.com© 2010 Tech Lighting, L.L.C. All rights reserved. The "T~trak" graphicis a registered trademark of T~trak. T~trak reserves the right tochange specifications for product improvements without notification.A Generation Brands Company2