Table of contents - Martin Archery

THE FUZION SINGLE CAM SYSTEMThe Fuzion system is unique among all other single cam systems. The Fuzionsystem has an Adjustable Perimeter Weight, modular draw length adjustment, and canbe adjusted in half inch adjustments within each draw length module.ADJUSTING THE DRAW LENGTHThe Fuzion Single Cam System boasts arevolutionary design and is engineered to give youpeak performance and speed. Using draw lengthmodules, the draw length can be adjusted in 1"increments (see fig. 1) The modules can also beused to adjust the let-off. A high let-off module ismarked as F-#. A 65% let off module is markedwith a F-#\. The slash on the end of the sizenumber indicates 65% let-off. To change the drawlength replace the module on the cam by removingthe screws that hold it to the cam (see Fig.3).NOTE: do not draw your bow without the moduleinstalled. It will damage your harness. TheFuzion module sizes range from F-2 to F-7. Ifyou would like to increase the draw length select ahigher number. If you would like to decrease theFig.1draw length select a lower number. The draw lengthcan also be adjusted up or down ½" using the pegs on the back of the cam (see fig.1).The #2 peg is the prescribed draw length for each module. The #1 peg is ½" longerand the #3 peg is ½" shorter. The draw weight will change one pound, accordingly,when using the peg adjustment.SETTING THE TILLERYour Fuzion bow should start out with an even tiller setting. Even tiller, or "0"tiller, makes sure both limb bolts are adjusted evenly. Single cam systems do not allowthe string to be parallel with the riser. The tiller cannot be measured in a standardmanner. To check the tiller on the Fuzion System, stretch a thin string or dental flossfrom axle-to-axle and measure from each limb cup to the dental floss. (see Fig.2)Fig.210