You cannot download Flash but only read this ... - Schneider Electric

AccessoriesPower distributionBusbars and blocksMulticlip distribution block● Distribution in a full row (48 steps) of modular switchgear. Generally supplied ona busbar.● The outlets are connected by the front, without screws on the spring terminals.The contact pressure of the cable is independent from the operator.● It adapts automatically to the cross-section of the conductor (min. cross-section1 mm 2 ).● Each spring only accepts one flexible cable at a time.● Degree of protection: IPxxB (protection against direct contacts).● Installation: clipped onto the rear of a modular rail, for example Ref. 03004, orscrewed on mounting plates (see page 140).● Electrical characteristics:– Rated insulation voltage: Ui = 750 V.– Rated impulse withstand voltage: Uimp = 8 kV.– Resistance to short-circuit currents: the interrupting capacity reinforced by filiationis conserved in the case of automatic switch associations.– 200 A Multiclip:• 10 mm 2 cable outlet: Imax = 50 A.• 2 different outlets with cables of 10 mm 2 : Imax = 63 A.● Distribution:– For 2-pole 200 A Multiclip (04012):• 12 phase and neutral connection points.– For 3-pole and 4-pole 200 A Multiclip (04013 and 04014):• 12 connection points for each phase.• 18 connection points for the neutral.Supply: Multiclip distribution block, 10 mm 2 bared copper connections with alength of 100 mm, 2 bags of 12 connections, terminal covers for the supplypoles (IPxxB), screws for the supply poles and fixing elements.ModelReference200 A 2-pole 04012200 A 3-pole 04013200 A 4-pole 04014216