DECLARATION OF PERFORMANCE

DECLARATION OF PERFORMANCEDoP No. 0679-CPD-0789(alternative CPD No. 0679-CPD-0748)1. Unique identification code of the product-type:Powers PB-PROType, batch or serial number or any other element allowing identification of the construction product asrequired pursuant to Article 11(4):ETA-12/0174Batch number: see packaging of the product.Intended use or uses of the construction product, in accordance with the applicable harmonised technicalspecification, as foreseen by the manufacturer:generic type Torque-controlled expansion anchor made of galvanized steel, sizes M8, M10,M12 and M16for use in Cracked and uncracked concrete, C20/25 to C50/60 acc. to EN 206option / category ETAG 001-2, Option1,loading Static and quasi-static, Fire (TR 020)materialzinc-plated steel:dry internal conditions onlycovered sizes: M8, M10, M12, M16temperature range Not applicable2. Name, registered trade name or registered trade mark and contact address of the manufacturer as requiredpursuant to Article 11(5):Product name: PB-PRO-SPowers Fasteners Europe B.V.Westrak 2081771SV WieringewerfThe Netherlands3. Where applicable, name and contact address of the authorised representative whose mandate covers thetasks specified in Article 12(2): --4. System or systems of assessment and verification of constancy of performance of the construction productas set out in Annex V: System 15. In case of the declaration of performance concerning a construction product covered by a harmonisedstandard: --6. In case of the declaration of performance concerning a construction product for which a European TechnicalAssessment has been issued:Centre Scientific et Technique du Bâtiment CSTB Paris issued: ETA-12/0174on the basis of ETAG 001-2, Option1The notified body 0679-CPD performed certification of factory production control on the basis of:- initial inspection of factory and of factory production control;- continuous surveillance, assessment and approval of factory production control.DoP No. 0679-CPD-0789 (R1) 1

9. Declared performance:EssentialCharacteristicscharacteristicresistancefor tensioncharacteristicresistancefor shearminimum spacing andminimum edgedistancedisplacement forserviceability limitstateDesign MethodETAG 001, AnnexA, method AETAG 001, AnnexA, method AETAG 001, AnnexA, method AETAG 001, AnnexA, method APerformanceETA-12/0174, annex 4ETA-12/0174, annex 6ETA-12/0174, annex 3ETA-12/0174, annex 5 and annex6HarmonizedTechnicalSpecificationETAG 001-02Where pursuant to Article 37 or 38 in the Specific Technical Documentation has been used, therequirements with which the product complies: --10. The performance of the product identified in points 1 and 2 is in conformity with the declared performance inpoint 9.This declaration of performance is issued under the sole responsibility of the manufacturer identified in point 4.Signed for and on behalf of the manufacturer by:_________________________Colin EarlVP HTF CDIY Europe___________________________Dr. Ing. Thilo PregartnerSenior Engineering ManagerDoP No. 0679-CPD-0789 (R1) 2