Sanford China Marker

MATERIAL SAFETY DATA SHEET MSDS # 02089Section One:IdentificationSanford, L.P.2707 Butterfield RoadOak Brook, IL 60523 USA800-323-0749 or 630-481-2000Product Name:Colors:Sanford China MarkerBlack, Red, Blue, Green, Yellow, Brite Orange, Crimson Red, White, Thin BlackEMERGENCY MEDICAL NUMBER:888-786-0972Sanford is a member of The Art and Creative Materials Institute, Inc. This product is certified by the Institute to be labeled in accordance withthe voluntary chronic hazard labeling standard ASTM D-4236 and is labeled with the AP Non Toxic Seal. Products bearing the AP ApprovedProduct Seal of The Art and Creative Materials Institute, Inc. are certified in a program of toxicological evaluation by a medical expert, subjectto review by the Institute Toxicology Advisory Board, to contain no materials in sufficient quantities to be toxic or injurious to humans, or tocause acute toxicity or chronic health problems.Section Two:Hazard IdentificationThis product is considered safe under normal use conditions.Section Three:CompositionWax, pigments, fillersSection Four:Inhalation:Skin Contact:Eye Contact:Ingestion:Section Five:First Aid MeasuresThis product is considered safe under normal use conditions.This product is considered safe under normal use conditions.This product is considered safe under normal use conditions.This product is considered safe under normal use conditions.Fire Fighting MeasuresFlash Point:N/AFlammability Limits (% by volume): Lower: N/A Upper: N/AExtinguishing Media:Special Fire Fighting Measures:Unusual Fire and Explosion Hazards:N/APencil Products stored in bulk are subject to ignition by fire and may, in the case of a fire, release toxic andother irritating gases. A self-contained breathing apparatus should be used when there is a potentialexposure to combustion products of pencils burning in bulk.N/ASection Six:Accidental Release MeasuresIn Case of Spill or Accidental Release:Normal clean up.Section Seven:Handling:Storage:Section Eight:Eye Protection:Clothing:Respirator:Ventilation:Handling and StorageNo special handling requirements.No special storage requirements.Exposure Controls and Personal ProtectionNone under normal use conditions.None under normal use conditions.None under normal use conditions.None under normal use conditions.February 17, 2010 Page 1 of 2

MATERIAL SAFETY DATA SHEET MSDS # 02089Section Nine:Boiling Point:Specific Gravity:Vapor Pressure:Solubility in Water:Evaporation Rate:Appearance/Odor:Section Ten:Physical and Chemical PropertiesFor core unless otherwise specified:N/AN/AN/AN/AN/AColored pencil; no odorStability and ReactivityStability:Conditions to Avoid:Chemical Incompatibility:Hazardous Decomposition:Hazardous Polymerization:Section Eleven:StableHigh heat and open flameNone knownNone knownWill not occurToxicological InformationSee Section Two: Hazard Identification for any hazardsSection Twelve:Ecological InformationNot availableSection Thirteen:Disposal ConsiderationsDispose in accordance with Federal, State, and Local Regulations.Section Fourteen:DOT:IATA:IMO:Section Fifteen:TSCA:Section Sixteen:Transport InformationNot regulatedNot regulatedNot regulatedRegulatory InformationThe product listed on this Material Safety Data Sheet is not listed on the Toxic Substances Control Act Inventory.All ingredients used to manufacture this product are listed on the TSCA InventoryOther InformationHMIS CodeHealthN/AFlammabilityN/AReactivityN/APersonal Protection N/A0=Minimal / 4 = SevereSanford has been advised by Counsel that the OSHA Hazard Communication Standard and the HealthCanada Workplace Hazardous Materials Information Standard do not apply to the Sanford Product describedin this Material Safety Data Sheet. The reasons for the exemptions are contained in 29 CFR1910.1200(b)(6)(ix) as amended Sept 14, 2009 per the Code of Federal Regulations and also CanadianHazardous Products Act part 12 section (f) as amended June 1, 2009. The information contained in thisMSDS is forwarded to you for your information, but is not meant to imply that the product is covered by nor isthis MSDS meant to comply with all requirements of the hazard communication standards.February 17, 2010 Page 2 of 2