Chemical Compatibility Guide - OEC Fluid Handling, Inc.

More documents

Recommendations

Info

Aro is pleased to present this selection guide to provide a convenientand informative reference point for pump selection.This information was compiled from information provided by materialsuppliers and manufacturers.The compatibility listings are intended as a guide only. We assumeno liability for their accuracy on their use. The user should test undertheir own operating conditions to determine the suitability of anycompound and material in a particular application.
THERMOPLASTIC ELASTOMERS (TPE’s) verses THERMOSETTING RUBBER DIAPHRAGMSAro’s direction has been to move toward replacement of traditional thermoset rubber diaphragms with thermoplastic elastomers (TPE). Examples of TPE’s include:Santoprene, Nitrile (TPE) and Hytrel.TPE’s are manufactured using a plastic injection molding process where the resin, or diaphragm material, is melted and injected into a mold to produce thediaphragm. The advantages of this process includes:FeaturesDiaphragm is molded to optimum shapeHomogenous partHigh performance resinsInjection molded/tight process controlBenefitsExcellent flex lifeNo delamination failuresChemical, abrasion and flex lifeLow cost/consistent performance1Laboratory testing has shown:Santoprene outperformed all rubber diaphragms except Buna in the mild abrasive fluids.The Geolast diaphragm had equivalent life to the Buna diaphragms and was superior to the otherrubbers compounds.Teflon with the Santoprene backer exhibited the best flex life of all diaphragms during the test series.Injection Mold ProcessMolded DiaphragmTraditional thermoset includes: Buna-N (TS), EPR, Neoprene, VitonThermosets diaphragms are constructed by sandwiching (laminating) a layer of fabric reinforcementbetween two sheets of unvulcanized rubber. These are placed in a mold and compressed underheat and pressure to bond and vulcanite the rubber.Limitations of the process includes:Inclusion of fabric limits design flexibility toachieve optimum diaphragm shape.Fabric does not remain centered between thetwo rubber sheetsIncomplete bonding can occurTime/Labor intensiveInconsistent quality“Wicking” of fabricResultsLower flex lifePoor abrasion / chemical attackDelaminationExpensiveInconsistent lifeDelamination / LeakageThermoset Mold Process(Lamination)RubberFabricRubber
Page 1: Chemical Compatibility Guide
Page 5 and 6: 3HALOGENATED SOLVENTS EXPLOSION HAZ
Page 7 and 8: 5Compatibility GuideA=Excellent, B=
Page 9 and 10: Compatibility GuideA=Excellent, B=G
Page 23: Compatibility GuideA=Excellent, B=G
Page 30: Aro’s Worldwide Commitment to Cus

Chemical Compatibility Guide - OEC Fluid Handling, Inc.

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?