the epocast marine handbook - HA SPRINGER - marine + industrie ...

H.A. SPRINGER GMBH
AN ILLINOIS TOOL WORKS COMPANY EPOCAST MARINE HANDBOOK
3 .0 . MARINE DESIGN INSTRUCTIONS
3.1. INTRODUCTION
3.2. EPOCAST 36® AND EPOCAST D
3.3. THICKNESS
3.4. BEDPLATE AREAS TOO SMALL
3.5. SPREADER PLATE
3.6. MIXING IRON AND RESIN CHOCKS
3.7. SMALL CHOCKS
3.8. CHOCK LENGTH
3.9. COMPRESSION ON BOLTING DOWN
3.10. CRITICAL ALGINMENT DESIGN RULES
3.11. PLANS FOR CLASSIFICATION SOCIETY APPROVAL
3.12. BOLT STRETCH
3.13. TO FIND BOLT TORQUE OR TENSION
3.14. TO FIND HYDRAULIC PRESSURE TO TENSION BOLTS
3.15. FITTED BOLTS
3.16. CONTACT H.A. SPRINGER GMBH FOR CALCULATIONS & DRAWINGS
3.17. UNIFORM LOAD DISTRIBUTION
3.18. NON-CRITICAL ALIGNMENT DESIGN RULES
3.19. WHEN TO USE EPOCAST D
3.20. OTHER APPLICATIONS
3.21. STRENGTH OF BOLTS
4.0 . MATERIALS, TOOLS AND TEST EQUIPMENT
Proprietary Rights
This handbook shall not be copied, reproduced or translated
in part or in whole without the prior written permission of
H.A. SPRINGER GmbH.
Copyright (c) H.A. SPRINGER
marine + industrie
service GmbH
Liebigstraße 21
D-24145 Kiel - Germany