2013 Atlas Catalog - Atlas Automotive Equipment

More documents

Recommendations

Info

Two Post LiftsOH-9000Atlas OH-9000 Series of above ground, commercialgrade two-post lifts are the perfect choice for commercialgarages or Mr. Homeowners who demand the highestquality at the absolute best price.The standard OH-9000, the Extra Wide OH-9000Wand the Extra Tall OH-9000H have Super-Symmetricfront arms and adjustable height columns.Atlas OH-9000 SpecificationsCapacity9,000 lb.Overall Height 142 1/2" - 150 1/2”(11' 10 1/2" - 12' 6 1/2")Overall Floor Width 135” (11’ 3”)Outside Column To Outside Column 125 3/4 (10’ 5 3/4”)Maximum Lift Height (Without Adapters) 70 3/4” (5’ 10 3/4”)Maximum Lift Height (With Adapters) 81 3/4” (6’ 9 3/4”)Minimum Arm Height 4 3/4”Inside Column 112 1/8” (9’ 4 1/8”)Drive Thru 97 1/4” (8’ 1 1/4”)Motor/Electrical Requirement220 Volt, Single (1) Phase.A 30 amp Breaker Is Recommended.Shipping Weight1,450 lb.Features• 9,000 lb. Capacity• Commercial Grade• Direct Drive Cylinders• 3-Stage Super-Symmetric Front Arms• Adjustable HeightSymmetric Columns• Powder Coat Finish• Clear Floor Design• Free Truck Adapters• Mounting Hardware• 5-Year Structural, 2-YearPower Unit WarrantyOH9 Extension KitsAtlas OH-9000 extension kits (width and height) are available when you buy the OH-9000 or may be purchased in thefuture if you later decide you need the extra width or height that these extension kits provide.OH-9000 WThe Atlas OH-9000W is the wider version of the Atlas OH-9000. The OH-9000Wis 6“ wider than the standard Atlas OH-9000, giving it an overall width of 141”(11’ 9”) and a drive thru width of 103 1/4” (8’ 7 1/4”). The extra width allowsextra wide vehicles and trailers to be pulled through.OH-9000 HThe Atlas OH-9000H is the taller version of the Atlas OH9000. The overheadbeam (that connects the two columns) is positioned two feet higher than theoverhead beam on the Atlas OH-9000. The taller position of the over head beamallows the OH-9000H to lift “taller” vehicles.6 | www.atlasautoequipment.comSpecifications Subject to Change. We are Not Responsible for Misprints.
Two Post LiftsOH-10XThis commercial grade two-post lift is the perfect choice for garagesthat demand the highest quality at the absolute best price. TheAtlas OH10X is WIDER and TALLER than most two-post lifts.Atlas OH-10X SpecificationsCapacity10,000 lb.Overall Height 152” (12’ 8”)Overall Floor Width 144 5/8” (12’ 5/8”)Outside Column To Outside Column 135 7/8” (11’ 3 7/8”)Maximum Lift Height (With Adapters) 84” (7’)Minimum Arm Height 4”Inside Column 117 1/2” (9’ 9 1/2”)Drive Thru 106 1/8” (8’ 10 1/8”)Motor / Electrical Requirement220 Volt, Single (1) PhaseA 30 amp Breaker Is RecommendedShipping Weight1,700 lb.Features• Commercial Grade• Direct Drive Cylinders• 2-Stage Heavy DutySymmetric Arms• Single Piece Columns• Symmetric Columns• Extra Long Carriages• Powder Coat Finish• 10,000 lb. Capacity• Clear Floor Design• Free Truck Adapters• Mounting Hardware• 5-Year Structural, 2-YearPower Unit WarrantyDirect Drive CylinderThe direct drive hydraulic cylinder configuration is thepreferred cylinder lifting system for commercial overheadtwo-post above ground lifts. The direct drive cylinderconfiguration has fewer moving parts than the chainover-rollercylinder configuration. In this direct driveconfiguration, it is actually the cylinder (attached to thecarriage) that moves up; as the hollow piston rod exertspressure on the base of the column.The pressurized hydraulic fluid flows into the side ofthe cylinder rod (there is a metal cap on the end of rod)and moves up through the length of the hollow cylinderrod into the cylinder. The pressure of the hydraulic fluid(inside the cylinder) pushes against the top of the piston rod and the cylinder (attached to the carriage) travels up inside thecolumn. This is the process that raises the vehicle.The pressurized hydraulic fluid in the cylinder cannot move back down through the hollow rod against the pressure of thehydraulic fluid moving up. The top of the piston rod is slightly smaller than the inside of the honed cylinder. The piston headhas one polyurethane sealing O-ring located in the center groove of the head, and two positioning synthetic seal guideslocated near the top and bottom the piston rod head.The sealing O-ring prevents the cylinder’s pressurized hydraulic fluid from “seeping” around the piston head. The twopositioning seal guides prevent the metal piston head from contacting the honed cylinder walls during the travel sequence.This direct drive system, with fewer moving parts, ensures years of excellent lifting service from your Atlas above ground hoist.Specifications Subject to Change. We are Not Responsible for Misprints.www.atlasautoequipment.com | 7
Page 2 and 3: AboutAtlas automotive equipment can
Page 4 and 5: Two Post Lifts9OHSC-SSExtra Long Ca
Page 8 and 9: Two Post LiftsPV-10PThe Atlas PV10P
Page 10 and 11: Hobbyist Four Post Liftspro 8000The
Page 12 and 13: Commercial Four Post Lifts412 / 414
Page 14 and 15: Alignment Lifts12-ASLThe Atlas 12AS
Page 16 and 17: Rolling JacksRJ-35Designed for use
Page 19 and 20: Mid-Rise and Scissor LiftsFeatures
Page 21 and 22: Mid-Rise and Scissor LiftsMR 06Atla
Page 23 and 24: MC36K / MC48KThe Atlas 36,000 lb. M
Page 25 and 26: MC16000 | MC19000 | MC22500Features
Page 27 and 28: Mobile Column LiftsAccessoriesStand
Page 29 and 30: Motorcycle Lifts and AccessoriesHI-
Page 31 and 32: Tire ChangersAtlas Passenger Tire C
Page 33 and 34: Truck Tire ChangersTTC306The Atlas
Page 35 and 36: Tire Changer AccessoriesTire Change
Page 37 and 38: Wheel BalancersWB55The Atlas 3-D WB
Page 39 and 40: Brake Lathes9370C Brake LatheThe At
Page 41 and 42: Alignment MachinesEdge 801 With Blu
Page 43 and 44: 2-Post Overhead Lift ComparisonAtla
Page 45 and 46: Mid-Rise and Scissor Lift Compariso
Page 47 and 48: 4-Post Lift ComparisonAtlas Garage
Page 49 and 50: Wheel Balancer ComparisonAtlas WB11
Page 51 and 52: Truck Tire Changer ComparisonAtlas

2013 Atlas Catalog - Atlas Automotive Equipment

Create successful ePaper yourself

Delete template?

Save as template?