Â¥ 44A-ZC - Travis Industries Dealer Services Login Page

More documents

Recommendations

Info

ZERO CLEARANCE INSTALLATION (Continued)Blower Installation (Continued)Provided with the fireplace is a start collar with a section of 6" flex duct attached. Insert thestart collar into the knockout hole, reach through the duct and bend over the tabs to lock thestart collar in place. Stretch the flex duct to the collar on the blower housing and fasten inplace (6" warm air duct can be used if more duct is needed.). Connect the matching plugs onthe end of wires coming from the conduit and the wires coming from the top of the blowerhousing (See the illustration below). Push the wires and connectors through the hole into theblower housing and snap the snap-in conduit connector into the hole. Take the powerconduit and make it accessible to the electrician or hook up to the nearest electrical outlet.CAUTION: DO NOT RUN THE CONDUIT OVER THE TOP OF THE FIREPLACE IF THE LEFTKNOCK-OUT IS USED.NOTE: For a flush mounted blower housing the enclosure will have to be 36 1/2" from thecenter-line of the fireplace to the outside of the enclosure as shown in the blower portionof the section "ZERO CLEARANCE INSTALLATION - SPECIFICATIONS".TOPVIEWRing for ductFRAMING DIMENSIONS: Height: 13"Width: 11"Depth: 11 1/2"11"6"1 1/2"Hole forConduitSnap conduitconnector into thehole in the top ofthe blower housing.Conduit CoverPlate (On bothsides)FireplaceXtrordinairLocking TabsWire PlugsStart CollarBlower Housing13"6" BlowerHook-UpFlex DuctIntake grillmust beaccessible.Power Source (110 Volt A.C.)11 1/2"Facing and Hearth InstallationFollowing the specifications listed in the section titled "ZERO CLEARANCE INSTALLATION -SPECIFICATIONS", construct the facing and hearth following all building codes that mayapply. Make sure it adheres to all of the specifications listed. The facing should totallyenclose the fireplace into the chase.25
ZERO CLEARANCE INSTALLATION (Continued)INSTALLATION SPECIFICATIONS (See Installation Instructions)Mantle(Combustible orNon-Combustible)Ð Must be aminium of 23"from top edge offaceplateStandardWall Board5"Min.CombustibleFacingHeader23"Min.12"Min.4 1/2"Min.SpacerCoolingVents (2)Top Edge ofFaceplate1"(Typical)1/2"CementFiberboard16" 11 1/2"26"Non-CombustibleFacingCement Fiberboard or othernon-combustible material(i.e. brick stone or marble)Flange that nails to theframing (1/2" from frontof the fireplace)FIREPLACEXTRORDINAIRCHASE FRAMINGNon-CombustibleHearth Extension20" Min.Minimum1/2" cementfiberboard orequivalentUse one of threeblower ductlocations.2" Wide Sheet MetalEmber Protector26
Page 2 and 3: TABLE OF CONTENTSPageIMPORTANT INFO
Page 4 and 5: PREPARATION FOR ZERO CLEARANCE INST
Page 6 and 7: ZERO CLEARANCE INSTALLATION - SPECI
Page 28 and 29: DETAILING THE FIREPLACEAcid Wash An
Page 30 and 31: DETAILING THE FIREPLACE (Continued)
Page 32 and 33: DETAILING THE FIREPLACE (Continued)
Page 34: SAFETY LABELThe following is a copy

Â¥ 44A-ZC - Travis Industries Dealer Services Login Page

Create successful ePaper yourself

Delete template?

Save as template?