44 DV XXL - Travis Industries Dealer Services Login Page

Installation (for qualified installers only) 7Fireplace Placement RequirementsMinimum Framing DimensionsThe 1Ó stand-offs along the front corners, the 1Ó clearance requirement around the sides and back,and the 10-1/2" stand-offs on the top of the fireplace separate the fireplace from combustiblematerials (e.g.: combustible framing members, plywood, sheetrock, paper-backed insulation). Thestand-offs may contact the framing members but no material may be placed between the stand-offs orinto the required 1Ó clearance to the sides and back5-1/2" Clearance Min.(before firestop)Required Firestop (included withthe fireplace)75" Min.NOTE: if venting directly to the rear,make sure there is a min. 12" spacecentered behind the fireplace.The fireplace enclosuremust not be less than75" above the base ofthe fireplace.If using a remotecontrol or thermostat,route the wire to alocation near the gasline (include an extra 3'length for hookup).50-3/4"3" Clearance Min. (after firestop)1" Clearance min. to the sidesand below the vent (before orafter firestop).Minimum 65-1/2" above thebase of the fireplace (includes18" min. rise before elbow -see the section "HorizontalTermination Requirements")Gas line (3/8" M.P.T. or 1/2"F.P.T.) should be routed 6-12"behind the framing openingand 2-3/8" above the base ofthe fireplace (see "Gas LineConnection" for details).52"24-3/8"Route the electrical line to a positionat the right rear of the fireplace.NOTE: If using the power heat vent,allow for the duct passage whenframing the enclosure.• Fireplace must be installed on a level surface capable of supporting the fireplace and vent• Fireplace must be placed directly on wood or non-combustible surface (not on linoleum or carpet)• Due to the high temperature of the fireplace, it should be located out of traffic and away from furnitureand draperies.Travis Industries 93508109 180501