Resources

Page 18
www.osr.com
(CONTINUED FROM PAGE 9)
Figure 5—Success!
Step 5: Success!
If you’ve configured everything properly up to this point, you should be greeted with your familiar connection message from
WinDbg (Figure 5).
But What About Boot Debug?
In the above steps, we’ve only enabled normal kernel debugging. Sometimes it’s necessary to enable boot debugging, for example,
to allow you to load an unsigned boot start driver. Unfortunately, network boot debugging requires an EFI BIOS and is not
supported with a traditional PC-AT BIOS. While it should be possible to make this work in VMware Workstation (you can boot your
VM with an EFI BIOS), we were not able to make it work at the time of writing this article. If we figure out the magic steps to make
it work we’ll be sure to update.
Follow us!
WANNA KNOW KMDF?
Tip: you can read all the articles ever published in The NT Insider and still not come close to
what you will learn in one week in our KMDF seminar. So why not join us!
Upcoming presentations:
Amherst, NH 5-9 October
Palo Alto, CA 2-6 November
Amherst, NH 2-6 November
The NT Insider July - August 2015 © OSR Open Systems Resources, Inc.