and Accessories

More documents

Recommendations

Info

multi post poles C4P four post pole catalog no. mAximum allowable epa (MPH) POLE oah WT 85 90 100 110 120 130 140 150 C4P-8 8' (2.5m) 50 47.8 42.3 33.7 27.4 22.6 18.8 15.8 13.4 C4P-10 10' (3.1m) 58 37.1 32.7 25.8 20.7 16.9 13.8 11.4 9.5 C4P-12 12' (3.7m) 66 29.8 26.1 20.3 16.0 12.8 10.2 8.2 6.6 C4P-14 14' (4.3m) 71 24.2 21.1 16.1 12.4 9.6 7.5 5.7 4.3 C4P-16 16' (4.9m) 78 19.7 17.0 12.7 9.5 7.1 5.2 3.7 2.5 C4PB-8 8' (2.5m) 50 47.8 42.3 33.7 27.4 22.6 18.8 15.8 13.4 C4PB-10 10' (3.1m) 65 37.1 32.7 25.8 20.7 16.9 13.8 11.4 9.5 C4PB-12 12' (3.7m) 72 29.8 26.1 20.3 16.0 12.8 10.2 8.2 6.6 C4PB-14 14' (4.3m) 79 24.2 21.1 16.1 12.4 9.6 7.5 5.7 4.3 C4PB-16 16' (4.9m) 86 19.7 17.0 12.7 9.5 7.1 5.2 3.7 2.5 Note: Overall height is measured as shown (OAH). C4PB four post pole SPECIFICATIONS Base shall be cast aluminum #356 alloy, free of any porosity, foreign materials, or cosmetic fillers. Base casting shall be heat treated to a T-6 condition, and of uniform wall thickness, with no warping or mold shifting. warnings Caution must be exercised in the selection of a design wind speed when the pole is to be installed in a special wind region (as indicated by the wind map) or in an area where wind speed is unpredictable. AAL recommends consulting a local structural engineer when the pole is to be installed in an area that may be subject to extreme weather and exposure. Poles installed on structures such as buildings and bridges may be subjected to vibration, oscillations, and other fatigue effects which are not covered by the AAL warranty. The use of banners or other appendages can severely affect the loading of a pole. No banner or other appendage should be attached to an AAL pole unless approved by AAL. If the products are to be used on an existing foundation or on other structures, the customer assumes all responsibility for the structural integrity of the existing foundation, anchorage or structures and all the consequences arising therefrom. Caution Poles should never be erected without the luminaire installed. Warranty is voided if the pole is erected without the luminaire. The warranty is voided if the pole is not grouted under the entire base after installation. Anchor bolts shall be hot dip galvanized steel. Six galvanized hex nuts and flat washers, and a bolt circle template shall be provided. Anchor bolt for poles are 3/4" x 24" x 3" All concrete foundation details are the responsibility of a local structural engineer. Bolt projection 3 1/2" 84 POLES/ARMS/ACCESSORIES
T4P Traditional Four post pole catalog no. mAximum allowable epa (MPH) POLE oah WT 85 90 100 110 120 130 140 150 T4P-8 8' (2.5m) 103 43.6 38.7 30.9 25.1 20.7 17.3 14.6 12.4 T4P-10 10' (3.1m) 117 32.7 28.8 22.7 18.3 14.8 12.2 10.1 8.4 T4P-12 12' (3.7m) 131 25.5 22.3 17.3 13.6 10.8 8.7 6.9 5.5 T4P-14 14' (4.3m) 145 20.2 17.5 13.3 10.2 7.8 5.1 2.3 - T4P-16 16' (4.9m) 160 16.2 13.8 10.2 6.1 2.1 - - - Note: Overall height is measured as shown (OAH). SPECIFICATIONS Base shall be cast aluminum #356 alloy, free of any porosity, foreign materials, or cosmetic fillers. Base casting shall be heat treated to a T-6 condition, and of uniform wall thickness, with no warping or mold shifting. warnings Caution must be exercised in the selection of a design wind speed when the pole is to be installed in a special wind region (as indicated by the wind map) or in an area where wind speed is unpredictable. AAL recommends consulting a local structural engineer when the pole is to be installed in an area that may be subject to extreme weather and exposure. Poles installed on structures such as buildings and bridges may be subjected to vibration, oscillations, and other fatigue effects which are not covered by the AAL warranty. The use of banners or other appendages can severely affect the loading of a pole. No banner or other appendage should be attached to an AAL pole unless approved by AAL. If the products are to be used on an existing foundation or on other structures, the customer assumes all responsibility for the structural integrity of the existing foundation, anchorage or structures and all the consequences arising therefrom. Caution Poles should never be erected without the luminaire installed. Warranty is voided if the pole is erected without the luminaire. The warranty is voided if the pole is not grouted under the entire base after installation. Anchor bolts shall be hot dip galvanized steel. Eight galvanized hex nuts and flat washers, and a bolt circle template shall be provided. Anchor bolt for poles are 3/4" x 24" x 3". All concrete foundation details are the responsibility of a local structural engineer. Architectural Area Lighting 85
Page 1 and 2:
and Accessories Arms Contemporary A
Page 3 and 4:
PRM3-TRA35D-DB2 Architectural Area
Page 5 and 6:
Efficient • Effective • EnvirON
Page 7 and 8:
Contemporary Style LUMINAIRES Unive
Page 9 and 10:
2. Select a Mount and Arm Period Co
Page 11 and 12:
Specify the Best AAL traditional ca
Page 13 and 14:
ALL ARMS ARE notCREATED EQUAL Accep
Page 15 and 16:
WMA2L Wt: 14 lbs WMA3 Wt: 17 lbs 5
Page 17 and 18:
WMA4 Wt: 12 lbs WMA55 Wt: 10 lbs 25
Page 19 and 20:
WMA10 Wt: 16 lbs WMA11 Wt: 10 lbs 2
Page 21 and 22:
WMTP Wt: 34.5 lbs WMBL Wt: 32 lbs 2
Page 23 and 24:
TRA2L Wt: 9 lbs EPA: .75 TRA3 Wt: 1
Page 25 and 26:
TRA57 Wt: 7 lbs EPA: .67 TRA60 Wt:
Page 27 and 28:
TRA59D Wt: 3.35 lbs EPA: .13 10" 25
Page 29 and 30:
SLA4 Wt: 14 lbs EPA: 1.39 27 3/4" 6
Page 31 and 32:
SLA9-2 Wt: 24 lbs EPA: 2.44 SLA10 W
Page 33 and 34: 35.5" SLA18 Wt: 12 lbs EPA: .85 SLA
Page 35 and 36: 21" 525mm 22" 550mm PM3 ° 1 1/4" 3
Page 37 and 38: ALL ARMS ARE notCREATED EQUAL Accep
Page 39 and 40: wMA Wt: 10 lbs wma2 Wt: 13.87 lbs 2
Page 41 and 42: wma9U Wt: 8 lbs wma10 Wt: 16 lbs 3"
Page 43 and 44: wma24 Wt: 12 lbs wma35U Wt: 12 lbs
Page 45 and 46: SLA4 Wt: 14 lbs EPA: 1.39 SLA4-2 Wt
Page 47 and 48: SLA9-2 Wt: 24 lbs EPA: 2.44 SLA10 W
Page 49 and 50: SLA18 Wt: 12 lbs EPA: .85 SLA18-2 W
Page 51 and 52: SLA20C-2 Wt: 26 lbs EPA: 1.91 SLA20
Page 53 and 54: M2PXA Wt: 41 lbs EPA: 1.55 PT2 PER-
Page 55 and 56: 12" 300mm 12" 300mm 12" 4 3/8" 300m
Page 57 and 58: TRA7 Wt: 12 lbs EPA: .90 TRA7-2 Wt:
Page 59 and 60: 21" 525mm 22" 550mm pier MOUNT PM3
Page 61 and 62: AAL POLES PRM4-TRA35D AAL poles are
Page 63 and 64: PR3 3” round (rd) pole catalog no
Page 65 and 66: Aluminum poles PR4 4" round (rd) po
Page 67 and 68: Aluminum poles PS4 4" Square (sq) p
Page 69 and 70: BASE COVERS BASE COVERS SPECIFICATI
Page 71 and 72: DECORATIVE poles DB1 4" round (rd)
Page 73 and 74: DECORATIVE poles DB3 4" & 5" round
Page 81 and 82: COntemporary MULTI-post poles AAL C
Page 83: C3P tri post pole catalog no. mAxim
Page 87 and 88: Photocell options TENON LENGTH WILL
Page 89 and 90: acCessories Accessories banner arms
Page 91 and 92: ALN445-TRA1L Architectural Area Lig
show all

and Accessories

Create successful ePaper yourself

Delete template?

Save as template?