Instruction

More documents

Recommendations

Info

ERROR MESSAGES AND WARNINGS This charger incorporates a variety of functions for protection, these monitor the system to verify processes and the state of the electronics. In case of an error the screen will display the cause of error and emit and audible sound. The output is connected to a battery with incorrect polarity. This will be displayed if the unit detects a break in the circuit between the battery and output or if the battery is voluntarily disconnected during the charge process. There was a short circuit at OUTPUT. Erroneous selection of voltage of Lithium pack, please check the voltage of the battery pack. The voltage of the battery pack has been selected incorrectly! The charger has malfunctioned for some reason. Seek professional advice. The processor detects that the battery has dropped below the minimum voltage during the charge process. The voltage is higher than which is set. Please check the number of cells in the battery pack. Voltage of one cell in the battery pack is too low, please check the voltage of each cell. Voltage of one cell in the battery pack is too high, please check the voltage of each cell. Wrong connection of the connector detected; please check the connector and cable. The internal temperature is too high, please cool down. The processor cannot control the feeding current, please repair it.
MAXXTRAX 680 AC+ MAXXTRAX 650 CHARGEURS - EQUILIBREURS DIGITAL À MICRO-PROCESSEUR Manuel d’utilisation FRANCAIS
Page 1 and 2: MAXXTRAX 680 AC+ MAXXTRAX 650 MICRO
Page 3 and 4: WARNING AND SAFETY NOTES These warn
Page 5 and 6: Capacity limit: The charging capaci
Page 7 and 8: more charge cycles. The cyclic proc
Page 9 and 10: By pressing the “Batt Type/Stop
Page 11 and 12: 2. The value on the left side of th
Page 13 and 14: Number of cells Charging current Ba
Page 15 and 16: But in the manual mode, it will cha
Page 17 and 18: Start Enter Loading the data. Start
Page 19: 19
Page 23 and 24: AVERTISSEMENTS ET SÉCURITÉ Ces av
Page 25 and 26: Sécurité maximum Sensibilité Del
Page 27 and 28: vent ou utilisez un accu d’une pl
Page 29 and 30: gramme de charge et réglages utili
Page 31 and 32: 2. A gauche sur la 2ième ligne est
Page 33 and 34: Nombre d’éléments Tension de l
Page 35 and 36: mode. Type d’accu charge Tension
Page 37 and 38: Réglez le courant de décharge et
Page 39 and 40: 19
Page 43 and 44: WAARSCHUWING EN VEILIGHEIDSVOORSCHR
Page 45 and 46: Automatische laadstroomlimiet: Bij
Page 47 and 48: GEBRUIKERSINSTELLINGEN LIXX V. Type
Page 49 and 50: LITHIUM POLYMEER LAADPROGRAMMA’S
Page 51 and 52: 2. Als u een instelling wil verande
Page 53 and 54: Aantal cellen Ontlaadstroom Batteri
Page 55 and 56: Dit programma in “manual”- modu
Page 57 and 58: DEC INC > Start Enter > 3 sec - + <
Page 59 and 60: 19
Page 63 and 64: WARNUNGS UND SICHERHEITSHINWEISE Di
Page 65 and 66: Ladens von NiCd/NiMH verändern; di
Page 67 and 68: BEDIENUNGSEINSTELLUNGEN LIXX AKKU -
Page 69 and 70: LITHIUM POLYMER LADEPROGRAMME Wicht
Page 71 and 72:
2. Die linke Seite der oberen Zeile
Page 73 and 74:
Zellenanzahl Ladestrom Akkuspannung
Page 75 and 76:
“Inc” und “Dec” gleichzeiti
Page 77 and 78:
Abrufen von gespeicherten Daten Die
Page 79 and 80:
19
show all

Instruction

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?