INFORMATIVE BULLETIN No SPORTSTAR – 012 b

More documents

Recommendations

Info

EVEKTOR - AEROTECHNIK a.s. Letecká 1384 Tel.: +420 572 537 111 686 04 Kunovice Fax: +420 572 537 900 Czech Republic email: marketing@evektor.cz Pictures Instructions Re-install both left and right seat upholstery. Perform brake system test: Check proper function of the brakes during taxiing and at turns. Both brakes should be equaly effective. Otherwise repeat bleeding. Press and hold pressed brake pedal. Release bleeding screw on the brake cylinder. Brake fluid with air bubbles should run out. Tight the bleeding screw and release pressure on the pedal. Repeat this procedure until no bubbles are visible and just brake fluid runs out. QS-406/F-03A Page 14 of 19
EVEKTOR - AEROTECHNIK a.s. Letecká 1384 Tel.: +420 572 537 111 686 04 Kunovice Fax: +420 572 537 900 Czech Republic email: marketing@evektor.cz GENERAL INSTALLATION INSTRUCTIONS 1/ LOCTITE 577 sealant: 1. To get best possible results, all surfaces (external as well as internal) should be cleaned up with the Loctite cleaners and let dry sufficiently. 2. Apply Activator 7471 or 7649 if the material is a non-active like metal or curing time is too long and let dry.. 3. Apply a strip of adhesive all around the screw front threads, just not on the first thread. Crush adhesive into threads to fill the whole space in threads. For bigger diameter screws apply more adhesive as necessary to fill the threads and apply adhesive also into nut inner thread. 4. Ordinarily connect and use a pipe wrench to tight the screw joint as necessary to get proper position. 5. Properly tightened parts are immediately tight at mild pressure. The joint should cure at minimum for 24 hours to get maximum strength and resistivity againts solvents. 2/ MATCO BRAKE SYSTÉM FILLING AND BLEEDING Release slightly the bleeding screw on the brake cylinder (not fully to avoid drop out of a sealing ball). Screw off the reservoir cup. Fill reservoir untill brake fluid starts to run out from the bleed screw. Pressing of pedal speeds up filling. Filling is complete when brake fluid with no air bubbles runs out the bleeding screw. Put suitable bottle under the brake cylinder to catch brake fluid. Be carefull <strong>–</strong> protect your hands,as well as airplane painted parts, because the brake fluid is aggressive. Do not re-use run-out fluid. Recommended brake fluid level is about 15-20 mm ( 1/2“- 3/4“) below top edge. Screw down the reservoir cup, and clean it with a rag. Tight the bleeding screw on the brake cylinder. QS-406/F-03A Page 15 of 19
Page 1 and 2: EVEKTOR - AEROTECHNIK a.s. Letecká
Page 13: EVEKTOR - AEROTECHNIK a.s. Letecká
Page 19: EVEKTOR - AEROTECHNIK a.s. Letecká

INFORMATIVE BULLETIN No SPORTSTAR – 012 b

Create successful ePaper yourself

Delete template?

Save as template?