27.09.2015 Views

owner’s manual

2005 - Coastal Hot Spring Spas

2005 - Coastal Hot Spring Spas

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

spa’s limited warranty.<br />

If you install the spa outdoors, we recommend a reinforced concrete pad at least four inches thick. The reinforcing rod or mesh in the<br />

pad should be attached to a bond wire.<br />

If you place the spa on the ground, even temporarily, place stepping stones under the leveling areas (see Spa Leveling Instructions). The<br />

stones should be at least two inches thick and twelve inches square. Even with stones in place, the spa will inevitably settle and become<br />

unlevel. Plus, a spa surrounded by dirt or grass will soon be filled with dirt or grass from users’ feet; therefore, it is important to get it<br />

onto a solid foundation as soon as possible.<br />

HOW TO MOVE THE SOLANA SPA<br />

The Solana spa has been designed to be easy to move and install. For ease of handling, the spa should be moved as close as possible to<br />

the installation site before unpackaging. NOTE: Take care not to damage the spa with unpacking tools.<br />

NOTE: Before unpacking or moving the spa, verify that you have a clear pathway to its destination (measure if necessary).<br />

CAUTION: Do not slide or roll the spa on its side. This will damage the siding.<br />

REMOVAL AND REPLACEMENT OF THE FRONT ACCESS PANEL (TX SPA)<br />

Your TX spa uses three panels that are attached to the frame. These panels are referred to as side panels and a front panel. The front<br />

panel is located below the control panel. Behind the front panel, you’ll find all the electrical components. The front panel is held onto the<br />

frame with six Phillip screws.<br />

REMOVAL OF THE FRONT ACCESS PANEL<br />

• Remove the six screw caps - Place a flat head screwdriver between the panel and the screw cap, then carefully rotate the<br />

screwdriver to remove the screw cap.<br />

• Remove the six Phillip screws. - Starting with the upper right corner of the front panel followed by the two below, then repeat on<br />

the left side.<br />

• Remove the front access panel - The top of the front panel is tucked behind the lip of the spa shell. Push down on the upper right<br />

corner of the front panel (this will create a bow in the front panel) slide other hand behind the front access panel and pull front<br />

panel away from the spa.<br />

9

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!