Redbank Tunnel Deviation

Design /
planning
Pre-
Construction
Construction
Redbank Tunnel Deviation
Tahmoor Colliery
6 Environmental Control Measures
The following mitigation measures presented in Table 6.1 are intended to ameliorate impacts on noise and vibration. The strategies below are based on the
recommendations of the EA, Conditions of Approval and SoCs, Interim Construction Noise Guidelines (ICNG), Construction Noise Strategy (CNS).
Table 6.1Environmental Control Measures
Reference
Mitigation Measures
Documents
Responsibility
(if applicable)
Training and Inductions
Education on noise responsibilities will be provided as part of the site induction for staff and
subcontractors. The information within the induction will include:
all relevant project specific and standard noise and vibration mitigation measures
relevant licence and approval conditions
NV1
permissible hours of work
any limitations on high noise generating activities
location of nearest sensitive receivers
construction employee parking areas
• •
EA section 8.5
SoC24
CNS table 1
Foreman
Environmental
Coordinator (EC)
Superintendent
designated loading/unloading areas and procedures
site opening/closing times (including deliveries); and
Environmental incident procedures.
NV2
Ongoing education and feedback in relation to noise and vibration will be provided at
toolbox meetings and onsite training.
• Good Practice
Foreman
EC
NV3
All relevant staff and sub-contractors will be informed of areas and work practises where
potential noise impacts have been identified.
• SoC24
EC
Superintendent
RTD Annexure E NVMP Rev 0
Authorised: Regional Environmental Manager Revision: 0 © Abigroup Page 30