Gyro Compass Std 22 Installation and Service Manual(VER MAR

Installation and Service manual
Compass STD 22
Compass STD 22 Compact
3 Preparing to install the STD 22 Gyro Compass ............. 73
3.1 STD 22 Compass – Scope of Supply ......................... 73
3.1.1 General information concerning installation
of the STD 22 Compass .................................... 74
3.2 Creating cable connections ................................. 75
3.2.1 General information concerning on-board wiring ............... 75
3.2.1.1 General information about creating an earth connection ........ 78
3.3 Installing the compass and putting it into operation ............. 79
3.3.1 Remove the transportation support with outer sphere,
supporting liquid and distilled water .......................... 79
3.3.1.1 Assembling the compass enclosure .......................... 80
3.3.1.2 Installation of the gyrosphere ................................ 83
3.3.1.3 Filling with distilled water and supporting liquid ................ 85
3.3.1.4 Inserting the outer sphere in the compass enclosure ........... 87
3.4 Creating cable connections and plug connections .............. 89
3.4.1 Overview of plug connections and fuses on PCB‘s ............. 89
3.4.2 Creating a cable connection from
STD 22 Compass → Distribution Unit ........................ 91
3.4.2.1 Connecting to the power supply (Distribution Unit) ............. 92
3.4.2.2 Connecting the CAN bus plug ............................... 93
3.4.2.3 Setting the jumpers for the CAN bus ......................... 94
3.4.2.4 Switching the termination resistors for the CAN bus (E10 only) .. 95
3.4.2.5 Connecting the compass to earth ............................ 96
3.4.3 Switching on, settling and adjustment ........................ 97
3.4.3.1 Checks on the compass .................................... 97
3.4.3.2 Switching on the compass .................................. 99
3.4.3.3 Setting the compass zero (reference course) .................. 101
3.4.3.4 Reading the alignment error ................................ 103
3.4.3.5 Setting the CAN bus address ............................... 105
3.4.3.6 Adjustments of essential operating modes .................... 106
3.4.3.7 Function check on externally connected course receivers,
Function check of RoT ..................................... 113
4 Fuses, jumper, LED‘s, buttons and plugs ................... 115
5 DIP SWITCH settings ..................................... 117
5.1 Overview of functions of all DIP switch settings ................ 118
5.1.1 Adjustments of parameters (in ascending order of function) ..... 122
5.1.2 Adjustments of parameters
(in ascending order of their appearance) ...................... 124
5.1.3 7 segment displays and their meaning ........................ 126
5.1.4 Functional description of DIP switch settings (for general use) ... 127
5.1.5 Functional description of DIP switch settings (SEC) ............ 164
6 Tasks to be performed regularly ........................... 184
6.1 Changing the supporting liquid and distilled water .............. 184
6.1.1 Removing the outer sphere from the compass enclosure ....... 184
6.1.1.1 Draining out/filling in the supporting liquid and distilled water .... 186
6.2 Cleaning of the gyrosphere and the outer sphere .............. 189
3646/110--233.DOC010302
II
Edition: Feb. 05, 2007