Philips Avent DECT baby monitor - User manual - BUL

English 11
Nightlight
Note: You can also switch the nightlight on and off in the menu of the parent unit (see chapter ‘Menu
options’, section ‘Nightlight’).
1 Press the nightlight button Q on the baby unit to switch on the nightlight. (Fig. 24)
,,
Q appears on the display of the parent unit.
2 Press the nightlight button Q again to switch off the nightlight.
,,
The nightlight dims gradually before it goes out completely.
,,
Q disappears from the display of the parent unit.
Tip: Switch off the nightlight when you operate the baby unit on the non-rechargeable batteries. This
saves power.
Paging the parent unit
If you have misplaced the parent unit and its volume is switched off, you can use the PAGE button
on the baby unit to locate the parent unit.
Note: The paging function only works when the parent unit is switched on.
1 Press the PAGE button on the baby unit (Fig. 25).
,,
The message ‘Paging’ appears on the display of the parent unit.
,,
The parent unit produces a paging alert tone.
2 To stop the paging alert tone, press the PAGE button again or press any button on the parent
unit.
Lullaby function
Note: You can also operate the lullaby function in the menu of the parent unit (see chapter ‘Menu
options’, section ‘Lullaby function’).
1 Press the play/stop button E on the baby unit to play the currently selected
lullaby. (Fig. 26)
,,
The lullaby starts to play and repeats continuously.
2 To stop the lullaby, press the play/stop button E on the baby unit again. (Fig. 26)
3 To select another lullaby when a lullaby is playing: (Fig. 27)
--
Press the lullaby button K on the baby unit.
--
Wait 2 seconds for the next lullaby to start.
--
If you want another lullaby, press the lullaby button K on the baby unit again.
Out of range alert
When the parent unit is out of range of the baby unit, the parent unit beeps from time to time and
the message ‘Not linked’ appears on the display. The LINK light on the parent unit flashes red.
Note: The message ‘Not Linked’ also appears on the display of the parent unit when the baby unit is
switched off.
Menu options
Most functions can be operated on both the baby unit and the parent unit, but some functions can
only be operated in the menu of the parent unit.
Menu operation - general explanation
Note: Menu functions can only be operated when a connection has been established between the baby
unit and the parent unit.