Installation Guide UNO UL 110v V1.1

9. Installation materials
The following summary is a list of the parts likely to be required for the installation of the Pulpmatic
UNO macerators:
• 2” (50mm) pipe and fittings (swept bends only) to connect the waste output of the machine
to the soil pipe
• 2” (50mm) to 4”(110mm) adapter for each waste connection
• 7/8” (21.5mm) pipe and fittings to construct an overflow
• Suitable adapter to connect overflow to waste pipe (2” (50mm) to 7/8” (21.5mm) reducer or
similar)
• Tun dish or inline none return valve 7/8” (21.5mm) for the overflow
• Non-return valve fitted to cold water feed to the machine
• Faucet/tap with hose outlet fitted with ¾“ BSP male thread (must be accessible to machine
operator)
• Electrical isolation switch (must be accessible to machine operator)
• 30mA Residual Current Circuit Breaker
• Earth bonding kit
• Electrical cable (non UK machines)
9.1 Optional installation kit
DDC Dolphin Ltd offer an optional installation kit which provides a number of the parts required to
complete the installation. This is an extra cost option and not included with the machine.
Ground/Earth Lead
Green & Yellow cable to connect machine to the earth
clamp. A dedicated earth lug on the rear of the machine is
used to connect the cabinet of the machine to the copper
pipe water supply
Ground/Earth Clamp
To be attached to a copper water pipe within 1.2m of the
machine. The earth bonding cable above is connected to
this clamp
2” Rubber coupler (Export machines only, not
required for UK)
2” pipe has different external dimensions around the
world. This rubber coupler is used to overcome this
problem and allows UK 2” pipe to be coupled with any
type or size of 2” pipe
Copyright © 2015 DDC Dolphin Ltd Page 33 of 36 November 15 IGUL-UNO-V1.1