QAM/SMATV - Pace International

Leading, Simplifying
& Supporting
129
Both ports
output 18v
119
118.7
110
Particular Dish configuration will be
determined by DMA and satellites being used.
Consult with your Pace Sales Manager to
meet your specific needs.
Use tap to achieve
input to multiswitch
of -40dBm
129 HD transponder
118.7 SD transponders
110 SD transponders
119 HD transponder
Number of transcoders to be used will be determined by content being
broadcast. Typically:
36 TDT transponders to deliver core programming as well as DISHLATINO
+13 8PSK transcoders to include HD programming
+17 TDT transcoders to add International programming
TO DISH
TO DISH
DP-44
DP-44
TO M/Switch
TO RECEIVERS
TO M/Switch
TO RECEIVERS
Out to distribution
TO DISH
TO DISH
QAM/SMATV
DP-44
TO RECEIVERS
DP-44
TO M/Switch
TO M/Switch
TO RECEIVERS
TO DISH
Power supply included
and reqd. for each switch
Out to receivers
TO DISH
DP-44
TO RECEIVERS
DP-44
Power Supply
Power Supply
TO M/Switch
TO M/Switch
TO RECEIVERS
Typical 1 of 24 receivers
Tradewind parts as
required
HRS-6

QAM/SMATV
Digital Transmodulators
The Digital Transmodulators change the
input modulation (from satellite or terrestrial
transmitters) into a different output modulation
according to the reception device (a TV set or
a specific settop).
The following parameters can be programmed:
· Input and output channel/frequency
· Video and audio programming selection
· Video modulation index
· Audio frequency deviation
· Audio subcarrier frequency
· A/V subcarriers ratio
* For QPSK-QAM transmodulators: additional
selection of QAM format modulation and I/Q
format modulation.
TDT Transmodulator
5023
The Transparent Digital Transmodulater referred
to as the TDT+, turns the information contained
in a satellite transponder into a VHF or UHF
channel.
HD Transmodulator
5012
The 8PSK-QAM transcoder allocates the
information contained in a satellite transponder
no matter the modulations used (QPSK legacy,
QPSK Turbo or 8PSK) in a cable channel in VHF
or UHF.
Programming Unit
7234
TDT PSU - Power Supply Unit 120v
5030
DISH Q-Box
153989
The Q-Box allows compatible DISH Network®
satellite receivers to work in a commercial
QAM MDU environment. The Q-Box connects
in the home between the satellite receiver and
the QAM-enabled wall plate, receiving the
QAM-modulated signal and remodulating it as
QPSK so the satellite receiver can decode it.
TDT 19” Rack Adaptor
5301
All DISH QAM headends
can be custom built,
burned and balanced
by the headend experts
at Pace International or
built on site using our
RTA Racks!
Headend Management System (CDC)
· The aims of the Headend Management System
are:
· To allow the configuration and monitoring of
all the controllable devices in a headend from a
single point, via a Windows application.
· Present the information in an RF channel.
In addition, the Headend Management System
can carry out the following functions:
· Modifications in the configuration of the headend
elements, so that it becomes unnecessary
to go to the installation site to carry out any
changes.
· Fast scan of all the installation searching for any
faulty parts.
T05 Modem
5837
CDC - Headend
Management System
5051
Televes Hybrid Amplifier
4514
· Frequency range: 47~862 MHz
· Gain: 44dB
· Regulation margin: 20dB
· Output level: 60 dB
Ready to Assemble 39” Modular 4-post
Rack Extension - Top Section
RTA39T
Ready to Assemble 45” Modular 4-post
Rack - Bottom Section
RTA45B
Visit www.paceintl.com/edistribution for pricing and information or to purchase these products

QAM/SMATV
Tradewind Agile Micro Mod
PAMM
· Double heterodyne conversion
· Automatic band splitting filters for superior carrier
to noise ratio
· Supports TV, CATV, frequency and lock function
· FCC frequency offset with automatic setting
· Pre-emphasis defeat switch accessible from
side panel for the insertion of composite BTSC
stereo signal
· LED readout of channel on front display
Tradewind Mini Modulator
PMM
· SAW filtered for superior vestigial side band
shaping and harmonic reduction
· Microprocessor controlled frequency setting
meet all FCC accuracy and off setting requirement
· Upgrade to stereo with an optional stereo
encoder card (PMM-SEC)
· Channel can be reset within its band resetting
dip switch and output filter only
· Channels 2-92, listed on the front and rear
Digital ATSC or QAM Demodulator
PAD-HD
· ATSC compliant demodulation and FEC
decoding in 8VSB modes
· Wide range equalizer eliminates
multi-path effects
· Auto scan of
programmed channels
Dual Power Inserter for HD
PI-HD
· Range of 15-2150 MHz
· HD compatible
Tradewind Agile HD Processor
PAP-860
· For off-air channels
· Microprocessor controlled
· SAW filtered
· Adjacent channel rejection of 60 dB
· Superior low noise
· Sync tip AGC for precise signal regulation
· BTSC stereo signal compatible
· 45.75 MHz IF loop-thru
· Output capability to 860 MHz
· Stand by carrier generator
Tradewind 2x8 Port Rack Mounted
Multi Switch
PMSR-208
· Ideal for smaller systems
· Input selected by 14V/18V from satellite
receiver employing right and left hand circular
polarization
· Power adapter supplies power to LNBs
Tradewind 2x16 Port Rack Mounted
Multi Switch
PMSR-216
· Power adaptor supplies power to LNBs
· Input selected by 14/18V from satellite receiver
employing right and left hand circular polarization
· Built-in amplifier to compensate for insertion
loss
Tradewind Passive Combiners
PPC-12G - 12 Port
PPC-24G - 24 Port
· Directional coupler design
· High isolation
· Test point in front panel
· 3 year limited warranty
· Front panel A/V ratio adjust
Tradewind Rack Mount Chassis
PRC-12
· Tradewind Rack Chassis for Mini Mods
· Holds 12 Mini Mods with room for the PPS12
(power supply insert)
· 3 year limited warranty
Tradewind Power Supply Insert
PPS-12
· Fits in standard Mini Mod rack chassis
· Switching power supply included
· Built-in cooling fan
· 3 year limited warranty
Visit www.paceintl.com/edistribution for pricing and information or to purchase these products