Instruction of XB series Cycloidal gearbox

Table 8 Maintenance of accessories
Name Material Notice
Cycloidal wheel Bearing steel Replace when gear face or hole damaged
Gear Pin& sleeve Bearing steel Replace if damaged
Shaft pin Bearing steel Replace if damaged
Shaft sleeve Bearing steel Replace if damaged
bearing Bearing steel Replace if damaged
Oil seal Chemigum Replace and smear butter
Oil gauge polycarbonate Clean with neutral detergent
Gasket oil resistant rubber
asbestos
Paint sealant on two sides
8. Dismounting and Installation
DANGEROUS
Prohibit dismounting or reworking of reducer if it with explosion-proof
motor. Otherwise it may explosion, fire, electric shock, injury, damaging
equipment.
8.1 Dismounting and Reinstallation of reducer
Outflow the oil if it is filled with oil.
(picture 1)
Main accessories dismounting order
a. Make output shaft up---screw out the long hex bolt on reducer
body---dismount low speed part
b. Reducing part: output shaft sleeve—shaft retaining ring---high speed
bearing A---gasket or retaining ring---pin wheel A---gas ring---cam
sleeve(including its bearing)---pin wheel B---Key---retaining ring---needle
tooth shell---needle tooth sleeve.
c. Low speed part: end-shield---bearing stop-ring---output shaft (output
bearing A.B)
8.2 Reinstallation of reducer
The order of reinstallation is contrary to dismounting. Pay attention to the
following points:
9