And Guideways

Shaft And Support
Rail Units
TSNW..G4 d�25mm,
TSNW..G5 d�25mm SERIES
For details on part numbers, descriptive suffixes and various technical references, please refer to front of this section.
For engineering or technical information contact your local sales representative or call Distributor Sales (800)523-6572 or Linear Sales (800)462-3399.
SHAFT
DIAMETER
d LW
��� �� ���
� � � � � � � �
DIMENSION TABLE · Dimensions in mm
PART NUMBER MASS DIMENSIONS MOUNTING DIMENSIONS
�
a1 h 1
4 ) L2 ) a3 a6 C4 C 3
5/C6 ) C5/C 3
6 ) h1 h7 K 4
1 ) K6 K7 ACCURACY
CLASS5 )
h6 kg/m �2 min. max. DIN 6 912
12 TSNW 12 G4 1.6 40 22 �0.1 4,000 5 29 75 20 69 5 0.2 4.5 4.5 M4 �18 G4 0.03
16 TSNW 16 G4 2.5 45 26 �0.1 4,000 6.8 33 100 20 93 5 0.2 5.5 5.5 M5 �20 G4 0.03
20 TSNW 20 G4 3.8 52 32 �0.1 4,000 7.8 37 100 20 92 6 0.2 6.6 6.6 M6 �25 G4 0.03
25 TSNW 25 G4 5.3 57 36 �0.1 4,000 9.8 42 120 20 110 6 0.3 6.6 9 M8 �30 G4 0.03
30 TSNW 30 G5 7.5 69 42 �0.15 4,000 11 51 150 20 139 7 0.3 9 11 M10�35 G5 0.04
40 TSNW 40 G5 12.4 73 50 �0.15 4,000 14.5 55 200 20 189 8 0.3 9 11 M10�40 G5 0.04
50 TSNW 50 G5 18.9 84 60 �0.15 4,000 18.5 63 200 20 188 9 0.3 11 13.5 M12�45 G5 0.05
1 ) With reference to the nominal shaft diameter, measured while clamped.
2 ) Maximum length of single-piece units, the shaft protrudes beyond the support rail by about 2.5 mm at each end;
longer units are supplied as several pieces.
3 ) Dimensions C5 and C6 are dependent on the length of the shaft and support rail unit.
4 ) For fixing screws to DIN 6 912 and spring washers to DIN 7 980.
5 ) Value for the maximum variation of dimension h4,
measured on the same rail over a distance of 1 000 mm.
532
� �
� �
� �
� �
� �
� �
� ��
� �
� �
� �