OEM Data Sheet - Viasys

OEM
You want to make your cameras or video servers smarter ?
Your product supports 8 or 16 channels, but only very few with video analytics ?
You need hundreds of IV channels but you don't want to built up a whole
data center ?
Embedding viasys into your product is easier, cheaper and faster than you think !
viasys analytics can be embedded everyiwhere
viasys analytics can be integrated in almost anything that runs a CPU:
1.) in all edge devices
(cameras, video encoder/streamers, network devices like hubs and switches)
2.) centralized platforms (hardware/software) such as DVRs, VMS, or any server.
Only minimal resources needed to embed viasys
The viasys algorithm is by far the fastest and smartest analytical solution
available in the industry. Only some hundred Kbyte of flash memory and the
same amount of of RAM is required to run the full featured analytics. CPU usage
is usually lower than the CPU load of primitive “pixel counting” motion detection.
All operating systems are supported
viasys will run on any operating system that is able to execute and compile
programs written in the language “C”. For sure it will run under Linux and
Windows.
No initial cost, no upfront fees
viasys will not charge any development costs for the integration into OEM
partners hardware. Each party covers his own cost and has only to invest some
manpower into that integration.
Subject to technical changes. ©viasys intelligent video GmbH Version: 05.2010
www.viasys-iv.com

Intelligent Video Sensor Technology (3D, direction, sensitivity),
Reliable alerting especially in outdoor areas
ToDo‘s from OEM partner ToDo‘s from viasys
1.) Providing of information about
hardware / software system where
viasys edge analytics should be
integrated.
3.) Installation of a Software
Development Kit (SDK) on a viasys
server so that the viasys core
algorithm can be compiled.
5.) Integration and first test of viasys
analytics on partners device / system
From that moment viasys edge analytics already
runs on the OEM-partners system.
First performance and stability tests can be done.
2.) Check from viasys if partner system
is ok for viasys edge analytics
4.) Adaption of the core libraries to the
CPU, operating system and special
needs of the OEM partners target
system. Compiling of a core library
or even an executable for partners.
A short integration process to create a prototype
Only 1 to 3 months and in general only some man-day’s of development support
from the OEM partners side: The integration is not very complicated in most
cases and via:sys has already good experience in embedding ist solution
(e.g. Axis, IQeye, …).
“viasys software plug-in gives system integrators and OEM technology
partners a new level of flexibility to deploy this solution to existing edge
devices without any hardware upgrades”
Dirk Owerfeldt, Co-Founder and VP
Subject to technical changes. ©viasys intelligent video GmbH Version: 05.2010
www.viasys-iv.com