Vax W90 Disassembly
Disassembly Instructions for Vax W90-RU-P Rapide Ultra Carpet Cleaner
Disassembly Instructions for Vax W90-RU-P Rapide Ultra Carpet Cleaner
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Fig.3 Fig. 4<br />
Now remove the two silver screws from the water valve and remove the valve,<br />
disconnecting the two hoses, black at the front and yellow at the rear, secured with hose<br />
clips, and also disconnect the clear hose from the outlet below the clean water tank. It may<br />
help the disconnection of these hoses if they are softened by using a hair dryer or similar.<br />
Unscrew and remove the mains cable clamp near the top of the handle.<br />
Now press the handle release foot switch on the left to retract the locking mechanism and<br />
ease the handle out of its location on both sides, while assisting the three hoses through<br />
the hole in the handle on the left hand side and the mains cable on the right hand side.<br />
The handle can now be completely removed (Fig. 5).<br />
Remove the fan assembly<br />
Now disconnect the red hose secured by a hose clip from the wash tool valve (shown<br />
disconnected in Fig. 5). There are five screws which now have to be removed, one silver<br />
screw on the underside adjacent to the previously removed brushbar drive motor cover<br />
and four black screws on top. One of these is located below the location of the power on /<br />
off switch and one is in a similar position on the left hand side. There is also one screw on<br />
each side towards the rear of each foot pedal.<br />
Lift off the fan motor cover while assisting the red hose and mains wiring through the holes<br />
in the cover (Fig. 6). Note the location of the ferrite core through which the motor wires<br />
pass in case this becomes dislodged.