enlisted distribution and assignment system (edas) - Soldier Support ...

(RC) REQUISITION CREATE
ERC1 REQUISITION CREATION UNCLASSIFIED 00:00 18/MAR/09 ZJU-RC1
************************* DATA FOR REQUISITION CREATION ***********************
RQMOSE 63Z RQPLSN 8 RQRRD 0905 RQUIC 1DXAA
RQPRTY Z9 RQEXCL Y RQSQIE O RQASIE 00 __ __ __
RQLIC YY RQLLPR 00 RQLRPR 00 RQLSPR 00
RQPSIR Y RQPSST Y RQPPSR Y RQRGDS ______
RQSPRO Y RQTYPE I RQAPID I RQPOSN _ _
RQDTVL _ _ RQRSN A0 P(PRE-ALLOCATION) A(ALLOCATION) O(OPEN) O
ENTER THE NUMBER OF REQUISITIONS TO CREATE WITH THIS CRITERIA (01 - 999) 001
PRESS ENTER TO EDIT, F1 FOR HELP, OR F3 TO EXIT. WHERE NEXT - __
ZJURCP1
THE REQUISITION CREATION FUNCTION ALLOWS YOU TO CREATE UP TO 99 REQUISITIONS
WITH THE SAME CRITERIA. SPECIAL INSTRUCTIONS (SI) MAY BE CREATED IN THIS
FUNCTION.
SCREEN INSTRUCTIONS:
REQUIRED FIELDS: AS A MINIMUM, YOU ARE REQUIRED TO ENTER A VALUE INTO THE
FOLLOWING REQUISITION FIELDS: RQMOSE, RQPLSN, RQRRD, RQUPC, AND RQRSN.
FOR EXAMPLE, TO CREATE REQUISITIONS FOR RQMOSE 97E OR 98G, "RQLIC" MUST BE
CHANGED TO A VALID VALUE OTHER THAN "YY". RQBCMF WILL BE LEFT BLANK,
UNLESS THE RQMOSE IS 00Z.
DEFAULTS: IF RQLIC EQUALS A VALID VALUE OTHER THAN "YY" AND YOU DO NOT MODIFY
THE LANGUAGE PROFICIENCY LEVELS, RQLLPR, RQLRPR, AND RQLSPR WILL BE
DEFAULTED TO "10". IF YOU ENTER A VALID VALUE IN RQRGDS, RQTYPE WILL
DEFAULT TO VALUE "G". IF RQDTVAL IS LEFT BLANK (RQTRTY AND RQDPTS), THIS
INPUT FIELD WILL DEFAULT TO A VALUE THAT IS ON THE ORGDB FOR THAT RQUIC
AND RQRRD.
DOUBLE ENTRY: WHEN UPDATING FROM THIS SCREEN, YOU WILL BE REQUIRED TO PRESS
"ENTER" THE FIRST TIME. IF THERE WERE NO ENTRIES ON THE SCREEN, AN ERROR
MESSAGE WILL BE DISPLAYED AND THE REQUISITION FIELDS REQUIRING DATA WILL
BE HIGHLIGHTED. ENTER THE DESIRED REQUISITION DATA AND NUMBER OF
REQUISITIONS. PRESS "ENTER" TO EDIT. ALL ENTRIES WILL BE EDITED AND THE
SCREEN WILL BE DISPLAYED AGAIN FOR YOU SHOWING LOC, RQSTE, RQMGAU, DML,
RQCMAA, DMSL, AND UNTCA FILLED IN BY THE SYSTEM. PRESS "F2" TO POST YOUR
CHANGES. IF ANY CHANGES ARE MADE AFTER THE INITIAL ENTRY OF DATA, ALL THE
ENTRIES ON THE SCREEN WILL BE REEDITED. PRESS "F2" TO POST OR F3 TO EXIT
FROM THE FUNCTION.
Page 118