Purelux Catalogue 2018

More documents

Recommendations

Info

control gear - occupancy sensors Power source Power frequency HF system Time delay microwave sensor SPECIFICATIONS 220 – 240Vac 50 – 60 Hz 5.8GHz CW radar (ISM band) 8 sec to 12 minutes Detection angle 360° Daylight harvesting Rated load 30 lux (minimum setting) to daylight (maximum setting) (300 lux at 75% setting) 600W Power consumption 0.9W Weight Detection range Transmission power 67g 1 to 10 meters
emergency range - led luminaires LED Exit Sign PL / LED / EX FEATURES: • Provides up to 5 hours of emergency light • Samsung LED chip • Lamp type: 1 x 2W LED • Die-cast aluminium housing • White epoxy finish • Slim-line / Super thin • Low battery discharge protection • Reverse battery Protection Applications: Building regulatory exit-route indication The Emergency Exit Sign range of luminaires is ideally suited as stand-alone / self-contained surface mounted fittings in new or existing buildings, as required by regulations. The Emergency Exit Sign housing is a white epoxy powder coated steel frame with a green “EXIT” legend. The LED lamp is protected by a translucent opal polycarbonate diffuser that is attached to the body by means of specially designed and integral clip mechanism. The emergency exit sign contains a driver, 1x LED, associated control gear and ni-cad batteries for emergency power within the exit sign. Connection to the mains is by means of an internal terminal connector. These luminaires are available in the following versions: non-maintained, maintained or self-testing. The LED arrangement provides a uniform illumination of the signs / legends with a high level of emergency illumination at floor level or at the threshold of an exit door. 5 hours are provided of emergency lighting with the ni-cad batteries. A safety start circuit is provided to prevent emergency operation until mains are connected. This enables installation without disconnecting or unneccessarily depleting the batteries. Deep discharge protection is provided. These Exit sign luminaires can also be connected to 12V or 24V dc central battery systems with maintained or non-maintained operation. Luminaires are constructed to ensure that the batteries are never subjected to a high ambient temperature which accelerates the deterioration of the battery cells. The exit signs fully satisfy the requirements os SANS 1186-1:2003 and SABS 0114-2 and are designed to conform to the SANS 1186-3:2004. The use of graphic symbols in conjunction with text and appropriate arrows enable easy recognition of escape routes. construction All incoming wiring is terminated within a terminall block that is provided in the base. Normal and emergency control gear is mounted on a plug-in removable gear tray. Knock-outs are provided in the top of the luminaire, with besa box mounting facilities in the back. Various alternative types of fixings are available (ie. ceiling or cantilever brackets etc.) All luminaires are supplied with the appropriate lamps and the specified exit sign / legend. trading 29
Page 1 and 2: trading Product Catalogue 2018 031
Page 3 and 4: index Standard Range - Fluorescent
Page 5 and 6: standard range - fluorescent lumina
Page 19 and 20: ecessed led panel - luminaires Phot
Page 21 and 22: standard range - led bulkheads LED
Page 23 and 24: standard floodlight range - led lum
Page 25 and 26: standard floodlight range - led lum
Page 27: control gear - occupancy sensors Mi
Page 31 and 32: lighting accessories LED fashion wi
Page 33 and 34: fluorescent fittings featuring elec

Purelux Catalogue 2018

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?