6 Mistakes You Make While Setting Up a Computer System

More documents

Recommendations

Info

sometimes we make a mistake to forcefully plug the cables into the wrong pins even if the pins are of different shape. Tip: Squeeze the little 6-pin and 2-pin together to create an 8-pin connector. In many GPU cards, they need more than 6-pin or 8-pin connector. And make sure to connect all the required pins. Hanging Graphics Card When we connect GPU with the case and plug into power, make sure not to leave it hanging there. <strong>You</strong> need to plug in your graphics card into a slot on the motherland. Remove the rubber shield from the GPU, so that you would find a slot to plug it into a marching PC-Express lane on the motherboard. Tip: Don’t rely on the motherboard to carry all the weight. Push the graphics card into the slot and make sure to connect it with your card. Plugging The Motherboard Cables Wrong Way A motherboard is an important and sensitive component for the computer system. And if you are confused while plugging its cables, it might cause damage. The problem here is to see where to plug cables on the motherboard to make the system buttons work. Therefore, it is advisable to plug in the cables accordingly. 2
Tip: On the back of each tiny computer cable, there's a black arrow. Plug in the tiny motherboard cables in the slots before you insert other components. Not Pressing Power Cables There are several reasons for pressing power cables. Even if your motherboard or the graphics card powers up; and your system still remains off, you won’t be able to figure out what’s wrong there to make your computer work. But if you dig through the root cause, before calling the hardware expert or stressing out about it, give a tiny little push to your cables. In most cases, it works and starts your computer system. Though these cables looked like perfectly plugged in, it is important to make sure by pushing them towards the connector. This might damage your computer system if not plugged in correctly. Tip: Once you complete the setup of your system, make sure to check the computer cable connections properly before switching on the power button. Squishing <strong>You</strong>r Drive Cables The hard drive cables sometimes don’t fit inside your case. And you continue squishing them inside enough to close the doors of the computer 3
Page 1: 6 Mistakes You Make While Setting U
Page 5: Mistakes are common. And sometimes

6 Mistakes You Make While Setting Up a Computer System

Create successful ePaper yourself

Delete template?

Save as template?