GME Supply Catalog Version 19.4
GME Supply is North America's premier outfitter of fall protection, safety equipment, and gear for at-height workers, industry, and construction.
GME Supply is North America's premier outfitter of fall protection, safety equipment, and gear for at-height workers, industry, and construction.
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
ROPE 201
KNOTS
While tying knots is a very important skill to have when working with
rope, it’s equally important to recognize the effects they have. Knots can
seriously decrease the overall strength of the rope, not only while the
knot is tied in the rope, but even after the knot has been untied. This is
due to crimping and twisting that is often irreversible.
Knots can decrease rope strength by up to 50%, which could be
catastrophic in a life safety or overhead lifting and rigging scenario.
Studies have shown that a figure 8 knot, one commonly used to create
a looped termination at the end of a rope, causes ropes to break at 75-
80% of their typical strength. This decrease in MBS could be enough to
put the capacity below required safety factors.
ROPE & RESCUE // KERNMANTLE ROPE
A common reason knots are tied in ropes is to create an attachment
point to secure a rope to a structure or object. There are other options
available, which do not decrease the strength of the rope by nearly as
much as a knot.
RETIRING YOUR ROPE
Reasons to retire your rope immediately:
• Rope whose strength may have been compromised during use
• Rope which is subjected to uncontrolled or excessive loading
• Rope which is greater than 10 years old, regardless of history
& usage
• Rope whose history and past usage you are uncertain about
• Rope that has been exposed to heat, direct flame, or excessive
abrasion
Cut retired rope into short lengths to discourage future use - or discard it
entirely. A retired rope should not be stored, kept, or maintained in such
a way that it could inadvertently be used.
Pictures above showcase damaged rope cores and frayed/abraded sheath
TERMINATION OPTIONS
Termination Plates - A piece of hardware, typically made from
milled aluminum, which has multiple holes. Rope is fed through these
holes in a specific pattern, leaving the main hole at the end of the plate
as an attachment point.
Factory Sewn or Spliced Eyes - Many rope manufacturers
offer sewn eyes for kernmantle and double braid ropes, or hand spliced
terminations for three strand ropes. These terminations are designed to
drastically reduce the stress put on the rope to minimize strength loss.
They also typically include a protective thimble or abrasion resistant
sleeve to further protect the rope at the stress points.
Factory Installed Connectors - Rope manufacturers can also
include hardware connection options. Snaphooks with swivels are
included on many lifelines to make attachment even easier.
(800) 940-6762
55