Bullitt Light Bar Data Sheet

2.3 Flash Pattern: - If the flash patterns are not co-ordinated, i.e. certain banks of LED’s are on different
patterns, you will need to reset all the controllers to their original flash pattern
If you do not have a pattern select switch installed, apply the brown wire from the Bullitt cable to the
positive (+VE) supply on the battery for 2 seconds to reset all controllers to flash pattern 1
If a pattern select switch (momentary) is installed, simply hold the switch down for 2 seconds
Sync; Most Mega-Flash products have been pre-programmed to include a synchronised flash rate.
Products can be synchronised by connecting their yellow cables. All LED’s can be permanently
illuminated (cruise mode) by connecting the yellow cable to negative
Flash Pattern LP Bullitt Spartan DS Flashes (p/m)
1. Mega-Flash 732
2. Quad TA1 (tested amber)
/TB2 (tested blue)
3. Triple TA1/TB2 366
4. Double TA2/TB2 TA1/TB2 TA1/TB2 TA2/TB2 244
5. Single TA1/TB2 122
6. Hyper 480
488
If the flash patterns are not co-ordinated, i.e. certain banks of LED’s are on different patterns, you will
need to reset all the controllers to their original flash pattern
M001v1.0 Revised November 2017 - 10 -