Bullitt Light Bar Data Sheet

3.4 E-mail a high-resolution image to support@redtronic.co.uk. This should comprise of a closeup
view of the damaged area as well as a distance image showing the entire length of the Lightbar
It may be necessary to return the Lightbar to Redtronic for analysis. Damaged lenses that have been
replaced must be returned to Redtronic in every instance. Please contact support@redtronic.co.uk
for further assistance
IMPORTANT:
NEVER USE ANY SOLVENTS OR CLEANING PRODUCTS ON THE LIGHTBAR AS THIS WILL CAUSE
DAMAGE TO THE LENSES
3.5 Replacing a top lens
3.5.1 Power off the Lightbar. Remove the top lens of the Lightbar using M6 (5mm) & M4
(3mm) Hex head drill bits or drivers. Remove the M4 hex screws first, then the M6 hex
screws
M001v1.0 Revised November 2017 - 12 -