User Manual Triebel Reloading Dies

More documents

Info

Sizing cartridge cases Distance between knurled sleeve/interior sizer 1 and cartridge base The knurled sleeve/interior sizer must not contact the cartridge base. Spindle set correctly – The knurled sleeve does not extend beyond the die. Spindle set incorrectly – The knurled sleeve extends beyond the die. Setting the spindle for full-length dies and bench-rest neck sizer dies for calibers with short case lengths Factory supplied with special interior sizer; the knurled sleeve is not needed. Spindle set correctly – The interior sizer does not extend beyond the die. 1 The knurled sleeve is not needed for short cartridge cases www.triebel-guntools.de 10/37 User Manual-2.0
Sizing cartridge cases Setting the spindle Setting the spindle with the counter nut with spindle and the counter nut 1 Counter nut 2 Counter nut with spindle 3 Pressure spring 4 Stop for neck sizer ring 5 Interior expander 6 Ejector pin Setting the spindle 1. Screw the counter nut with spindle downward so that the knurled sleeve does not stick out beyond the die; see Die setting distances page 9. 2. Lock the setting with the counter nut. Setting the spindle with the fine adjuster For setting the seating depth of bullet seater dies and bench-rest bullet seater dies. The fine adjuster can be purchased as an option to provide simple stepless adjustment of the seating depth of the bullet. 1 Upper part of fine adjuster with fixing screw 2 Lower part of fine adjuster 3 Rotating the fine adjuster counterclockwise raises the spindle 4 Rotating the fine adjuster clockwise lowers the spindle Setting the seating depth 1. Loosen the existing counter nut of the spindle from the die. 2. Screw the lower part of the fine adjuster (2) onto the spindle of the die; see Die setting distances page 9. 3. Screw on the upper part of the fine adjuster and tighten the fixing screw by hand. 4. Seat the bullet to the desired depth. www.triebel-guntools.de 11/37 User Manual-2.0
Page 1 and 2: STAND 05/2023 SETTING RELOADING DIE
Page 3 and 4: Contents Contents Contact .........
Page 5 and 6: Safety instructions Safety instruct
Page 7 and 8: Notes on setting reloading dies Not
Page 9: Sizing cartridge cases Die setting
Page 13 and 14: Sizing cartridge cases Full-length
Page 15 and 16: Sizing cartridge cases Setting the
Page 17 and 18: Sizing cartridge cases Setting the
Page 19 and 20: Sizing cartridge cases Spindle with
Page 21 and 22: Sizing cartridge cases Multi-neck s
Page 23 and 24: Seating bullets Seating bullets Dur
Page 25 and 26: Seating bullets Setting the bullet
Page 27 and 28: Seating bullets Setting the bench-r
Page 29 and 30: Seating bullets Setting the expansi
Page 31 and 32: Replacing components Fitting the sp
Page 33 and 34: Troubleshooting Troubleshooting Fau
Page 35 and 36: Replacement parts Replacement parts

User Manual Triebel Reloading Dies

Create successful ePaper yourself

Delete template?

Save as template?