Exclusiv-Klett system en

Exclusiv-Klett system
Example assembly
Insulation for flat partition ceiling above rooms with similar use (19°C/19°C)
Requirement DIN EN 1264 R = 0.75 m 2 K/W (U = 1.33 W/m 2 K)
10 mm
15 mm
60 mm
Concrete floor/floor panel
85 mm
60 mm heating screed incl. system pipe 15 x 1.8 mm
15 mm composite panel “Exclusiv-Klett“ PUR/PE 10 + 5 mm
10 mm additional insulation EPS-DEO WLS 032
85 mm (without lining) R = 0.857 m 2 K/W
30 mm
Insulation against ground, outside air or unheated/partially heated rooms (cellar)
The required insulation results from the energy certificate of the building in compliance with the current requirements of
the Building Energy Act (GEG) and is prepared by the building planner/architect.
60 mm
60 mm
90 mm
Concrete floor/floor panel
60 mm heating screed incl. system pipe 15 x 1.8 mm
30 mm composite panel “Klett“ EPS-DES 30-2 WLS 040
90 mm (without lining) R = 0.75 m 2 K/W
30 mm 30 mm 30 mm 47 mm
60 mm
30 mm
Concrete floor/floor panel
Concrete floor/floor panel
137 mm
150 mm
60 mm heating screed incl. system pipe 15 x 1.8 mm
30 mm composite panel “Klett-Kompakt“ EPS-DEO WLS 032
47 mm additional insulation PUR 47 WLS 024
137 mm (without lining) R = 2.890 m 2 K/W
60 mm heating screed incl. system pipe 15 x 1.8 mm
30 mm composite panel “Klett-Kompakt“ EPS-DEO WLS 032
30 mm additional insulation EPS-DEO WLS 032
30 mm additional insulation EPS-DEO WLS 032
150 mm (without lining) R = 2.813 m 2 K/W
11