simatic-st70-2019

© Siemens 2019
LOGO! Logic Modules
LOGO!Power
1-phase, 5 V DC
■ Technical specifications (continued)
2
Article number 6EP3310-6SB00-0AY0 6EP3311-6SB00-0AY0
Product LOGO!Power LOGO!Power
Power supply, type 5 V/3 A 5 V/6.3 A
Output
Output Controlled, isolated DC voltage Controlled, isolated DC voltage
Rated voltage V out DC 5V 5V
Total tolerance, static ± 3% 3%
Static mains compensation, approx. 0.1 % 0.1 %
Static load balancing, approx. 0.1 % 0.1 %
Residual ripple peak-peak, max. 100 mV 100 mV
Residual ripple peak-peak, typ. 30 mV 30 mV
Spikes peak-peak, max.
100 mV 100 mV
(bandwidth: 20 MHz)
Spikes peak-peak, typ.
50 mV 50 mV
(bandwidth: 20 MHz)
Adjustment range 4.6 ... 5.4 V 4.6 ... 5.4 V
Product function Output voltage Yes
Yes
adjustable
Output voltage setting via potentiometer via potentiometer
Status display Green LED for output voltage OK Green LED for output voltage OK
On/off behavior No overshoot of V out (soft start) No overshoot of V out (soft start)
Startup delay, max. 0.5 s 0.5 s
Voltage rise, typ. 100 ms 100 ms
Rated current value I out rated 3A 6.3 A
Current range 0 ... 3 A 0...6.3A
•Note +55 ... +70 °C: Derating 2%/K +55 ... +70 °C: Derating 2%/K
Supplied active power typical 15 W 31.5 W
Parallel switching for enhanced Yes
Yes
performance
Numbers of parallel switchable units 2 2
for enhanced performance
Efficiency
Efficiency at V out rated , I out rated , 76 % 80 %
approx.
Power loss at V out rated , I out rated , 5W
8W
approx.
Power loss [W] during no-load 0.3 W 0.3 W
operation maximum
Closed-loop control
Dynamic mains compensation 0.2 % 0.2 %
(V in rated ±15 %), max.
Dynamic load smoothing
5% 7%
(I out : 10/90/10 %), U out ± typ.
Load step setting time 10 to 90%, typ. 1ms
1ms
Load step setting time 90 to 10%, typ. 1ms
1ms
Protection and monitoring
Output overvoltage protection Yes, according to EN 60950-1 Yes, according to EN 60950-1
Current limitation, typ. 3.8 A 8.2 A
Property of the output
Yes
Yes
Short-circuit proof
Short-circuit protection Constant current characteristic Constant current characteristic
Enduring short circuit current
RMS value
• maximum 3.8 A 8.2 A
Overcurrent overload capability in overload capability 150% Iout rated typ. 200 ms
overload capability 150% Iout rated typ. 200 ms
normal operation
Overload/short-circuit indicator - -
measuring point for output current 50 mV =^ 3 A 50 mV =^ 6.3 A
Overcurrent overload capability when 150% I out rated typ. 200 ms 150% I out rated typ. 200 ms
switching on
2/38 Siemens ST 70 · 2019