Water softeners catalog

15000202-70 Single tank water softener valve FLECK 5600 SXT 1" electronic (Reg. Metered-time) 70lt. resin
15000202-75 Single tank water softener valve FLECK 5600 SXT 1" electronic (Reg. Metered-time) 75lt. resin
15000202-80 Single tank water softener valve FLECK 5600 SXT 1" electronic (Reg. Metered-time) 80lt. resin
FLECK 5600 SXT Electronic valve Automatic meter/time regeneration . Program with high performance
which allows a low water and salt per regeneration consumption. Valve body made of Noryl plastic material,
NSF listed. Programming is simple and fast, just enter time, day of week, time of regeneration, typically
02.00 at night, number of days between regenerations and hardness input. Complete with plug adapter
12/230V - 50Hz European plug.
Hardness regulator output. Is raccomended a minimum hardness in output of around 15 °F , but most
commonly used setting is not less than 5 ° F. Loosening setting screw will allow clapper by-pass to close.
The closing action will reduce mixing with raw water output. To mix a specific output hardness value, adjust
screw and test water. Repeat procedure until you reach desired hardness value. To check input/output
hardness from device, we recommend to buy cod. 13000001 Titrant kit total hardness (1°F) 15cc single
reagent.
TO BUY WITH EVERY SOFTENER
1x 15000407 Chlorine generator complete with fittings
1X 02001014 3-pieces standard housing 10" clear IN-OUT 1" with wrench & wall mounting bracket.
2X 04001006-05 Ionicore wound polypropylene cartridge 9-3/4'' - 50 micron (50)
1X Kit 13000001 Titrant total hardness (1 ° F) 15cc single reagent.
* Water softeners are supplied without salt, we recommend to use pads salt.
* Single tank water softeners are supplied filled until 40lt version
The device is supplied with chlorine producer assembled ( if ordered) and programmed with a input
hardness of 40°F, hardness of 0°F output and a safety regeneration every 7 days.
The bypass valves isolate device from water system and allow the use of untreated water. Routine
maintenance or service may also require that system is put in bypass.
What are the benefits that SXT Controller offer?
* Simple and intuitive programming.
* Large blue backlight LCD display.
* 48 hours of internal power backup
* Real day time in hours and minutes.
* Residual volume of softened water.
* Display of regeneration phases and cycle remaining time.
* Service and self-diagnosis indicators.
* Fast and easy configuration of regeneration capacity, time and day.
* Advanced programming options, including ability to program up to 6 cycles of regeneration with
independent adjustment of time.
* The set program remains in memory and will not be lost in case of power outages.
* Electronic regeneration step-by-step
* Manually, delayed or immediate regeneration
Benefits and advantages
Reduction of water hardness, which is cause of scale. ENERGY SAVING: the device prevents formation of
deposits in pipes and hydraulic lines. Greater sense of wellness during shower. Skin soft and clean.
Increased duration of appliances and boilers. COST SAVING: reduction in use of soaps, fabric softeners
and chemicals. Reduced maintenance costs. Fully automatic operation. It should just worry about adding
salt in water softner.
Increased sodium (for drinking water)
Most of the sodium consumed is taken with foods, especially ones obtained with industrial processing. Salt
is a great preservative and therefore is used as an additive for processed products. The assumption of
sodium with the water we drink is relatively low compared to that which is taken with food. All softeners to
produce softened water through ion exchange resins in, produce softened water output sodium ions. The
recommended sodium limit for water intended for human consumption is 200ppm liter. Depending on
sodium concentration and water hardness, it is possible that water presents an higher sodium concentration
than recommended. Where this is the case or if you need to follow a low salt content, it is advisable to
04 May 2021 48/101